1.) verify the BCM lan addresses and masks when you hyperterm in.
2.) As stated above, double check your pc's LAN address is set accordingly
3.) Make sure someone didn't swap your cross over cable w/ a straight though cable.
Are your destination codes routed for 1st and 2nd choice for Schedule 4? Also, are you disabling the PRI and testing? If so, what does the display say when you attempt to dial out with the PRI disabled?
No DST patch and your BCM set to one of the time zones that biv343 refered to and you'll be fine. No patch and your BCM set to a time zone that utilizes Daylight Savings, be prepared to adjust the time on April 1st.
Are your prompts split between the main company greeting and a CCR tree? The CCR tree will have to be disabled, prompts uploaded and then the CCR tree reenabled in the greeting table. You cannot change a CCR tree in any way without taking it out of service, saving your changes and putting the...
Record a company greeting for night......
Administer the night greeting in your greeting table for NON Business........
Program an F982 button on the attendant set (default p/w is O-P-E-R-A-T-O-R..........is changeable)
When the attendant leaves for the day, she hits F982, gives the password...
Definitly cannot channelize PRI. Since you have to route calls w/ dest. codes on PRI.......can you set a destination code for just your fax users? Say....all traffic is going out with a leading 9 in your destination codes (w/ exception to 411 and such) can you create a destenation code, say 8...
Since you have enabled your RAD password already, the next time you access RAD programming you will need to enter the RAD password, the "change" password will and should only appear after your password is logged. As it stands now, can you do a F9** and access RAD programming with your new...
So you entered and confirmed your new password via F9**, you attempt to dial in w/ NRU 10 and after you connect you get dropped and notified your password is incorrect?
I believe you will need to reconfig the CallPilot. Not sure about the keycodes after you reconfig. Out of curiousity, are you going to 4 digits on your DN's just to match your incomming DNIS digits?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.