Search results for query: *

You won't have any problems connecting to legend/magix systems since they use such a slow baud rate. Connecting to modems at speeds higher than 9600 are very unlikely. Same goes with any other VOIP type transport.

Nothing changed but you rebuilt the config??? I would say rebuilding the config from scratch would qualify as a change. Sure you didn't miss something or make a typo?

A much easier option for the original poster would have been a "bulk cable" faceplate. Leviton and I'm sure others also have a faceplate that is spit in half with a small hole in the middle. The part number escapes me right now but I've used them many times for restaurants that want a printer...

The other option for transfers to the other office would be a DXD card or voicemail autoattendant setup for the CO port being used. It doesn't need a fancy greeting, just something to let the employee know it answered. It would still require a "double transfer" but would be seemless to the...

There are also a few "white" 4610's and 4620's out there. I have one of each just because they are different.

I have had success with using a "flashhook" button(not a shortcode but the actual function) programmed on digital phones but never had much luck with the shortcode on analog phones.

:)

This works for all Palm smart phones... When the attachment is downloaded, tap on the small icon next to the attachment name. Select "Select Viewer" then choose "Voice Memo" It will remember your selection the next time you have a WAV file.

I'll swap you a 4424 with a broken display. lol

Or in the mean time, mobile twinning or remote forwarding will get you the basics.

If the idiots were smart......they wouldn't be idiots. lol

The Adtrans in the middle will have little effect unless they are configured to drop channels for data use etc. If that is the case, you would just need to configure the "B" channels that are assigned in the Adtran for such use and verify that channel 24 is assigned to the port for the PRI.

This might help... 1. Set Frame Format to Extended Super Frame Lines Trunks=>LS/GS/DS1=>enter slot + Enter =>Frame Format=>Extended Super Frame=>Enter. 2. Set Suppression Lines Trunks=>LS/GS/DS1=>enter slot + Enter =>Suppression=>B8ZS=>Enter. 3. Change Type to PRI. Lines...

You answered your own question. ;) All of the options you listed are valid. Another option might be to simply have the voicemail forward to email. I would say it is time to present the options to the customer and let them decide what would work best for them. My personal preference would be...

That's the easiest way. Although, the carrier should be able to busy out the line just as easy.

I have a new customer that I'm still getting familiar with the configuration that want to have calls forwarded to another office. 3 sites connected via SCN with centralized VMPro. All sites on release 3.1.65. All sites have a PRI(or partial). They currently have the "main number" at each...

Check around town for different phone service providers. Logix, Cbeyond, XO, and others can give you 48+ voice channels over a single T1 using VOIP technology. This can either be via SIP trunks to the IPO or via the PRI/T1 cards you already have. Do some shopping for cheaper service, or find...

Check out Valcom's paging options. It's much easier to let someone else reinvent the wheel. ;) http://voip.valcom.com/

I would hope you have tried the most obvious first step...change out the patch cord and/or test the cable between the IPO and switch.

Just an update for everyone following this thread..... Dawn(the original poster for this thread) cannot log in to the forum again for some reason, she wanted to give everyone a heads up that she's not ignoring anyone and appreciates the help given thus far.. The problems she's having are also...