Search results for query: *

The medical world around here still uses faxing of prescriptions to pharmacies. Email would be smarter but not a valid method. Marv ccna

Let me explain how the system and voice mail function. Calling a DN from another DN, the system rings the port associated with that DN. Simple When dialing into a voice mail Auto-attendant the caller is actually dialing the mailbox. When dialing mailbox 228 the DN associated to the MB (ext254)...

Are you calling the the site number in the app from site? PRI trunk to trunk transfer might be blocked by the telco. Try putting the number in the app and cAlling from from your cell. Marv ccna

1st. CLID needs to be enabled at the CO. It can be verified by using a POTS line phone with Caller ID capable. Caller ID is transmitted between the 1st and 2nd ring. 2nd. CLID needs to be turned on for each line in LINES > TELCO FEATURES 3rd. The phones you want to display Caller ID...

You may have to set the DIP switches for your country. Marv ccna

Is it possible the 1140e has a vlan set in it's config? This will stop connection, but will allow S1 and S2 to be populated and the the set to geet an IP address. Scroll through the entire terminal setup the vlan setting is near the end. Marv ccna

A windows update wll create a restore point to just before the update. You can try the restore and see if that fixes it. Marv ccna

Try this: 1. Once connected to the console of the device using OneAccess console cable. Press <ESCAPE>, then <CTRL>+Y and finally <CTRL>+N. 2. You will be prompted whether you want to factory reset the device. Type 'Y' for yes. 3. You will then be asked if you would like to reboot the router...

You should move the cross connect at the dmarc and the C-6 module, not the mod cords. Marv ccna

Simply put DN 225 as the ext for mailbox 100. If DN 225 has a mailbox already associated you will have to delete it first. Marv ccna

Caller dials 9 to change to ALT language. Marv ccna

??? Marv ccna

Wonder if the street light works. Marv ccna

Does this happen to and from all phones? Marv ccna

Typically cables are punch onto the back of a BIX1A and the feed to the back of a 5A or 7A. Then you cross connect from the the 5A front to the cables on the 1A. If you need more than 5 connections you can bridge the 5A sections together on the back. Marv ccna

not sure on the number of intercom buttons - would that restrict ability to xfer? Absolutely. You need a free I/C path to transfer. So if your calls appear on and I/C button you need a 2nd I/C to make a transfer. If call is on a line button only 1 I/C is needed on the phone. Marv ccna

DMC320 connection protocol Baud: 115200 bit/sec. Data bit: 8 Parity: None Stop bit: 1 Flow control: Hardware: DCD, DSR, DTR, CTS, RTS Null modem cable Marv ccna

You can also try F984 (call forward to voice mail) as an option. Marv ccna

The splash ring you are hearing is caused by Delayed Ring Transfer (DRT). It occurs when no phones are programmed to ring. By default the DRT is set to PRIME. You'll fine the PRIME set for each line under LINES programming, change them to NONE. Alternately you can change DRT from PRIME to NONE...

You can "hear" the disconnect from the CO. Put a butt set on the line in monitor mode. A few seconds after the far ends hangs up you will hear a buzz as the disconnect signal is sent from the CO. Marv ccna