Search results for query: *

Change the clocking to line timing.

To all, I am running HPov NNM Release B.06.20 on Windows 200 Server. Currently when I lunch the NNM application the event views freezes when it begins to load the eventDB. It gets to about 14% and crashes. HPOV is still working fine. Any Ideas. Thanks for the Help NetEng

I go with Ethereal for a sniffer and I use HPOV and syslog for Network Management.

Ok here is one way of doing it. The simplest way. You need to configure two port on each switch into VLAN 2. Then you need a cross over cable to connect each. The better way is to create a 802.1q trunk between each of the VLANs and trunk vlan 1 and 2.

Your going to need to send someone out there. Sorry

I maybe wrong on this I haven't worked on MPLS in a while and I don't have access to a lap big enough to test this. Also I maybe a little off on how traceroute works. But I think your assumption of not being able to see the transit network in MPLS could be wrong. In the routing table your...

HSRP will not help you in this situation.

I agree with vipergg. CDP can really help save time trouble shooting. just dont run it on any outside facing routers. The routers infront of the firewall should not run CDP.

You can write your own using perl and the Cisco:net:telnet module

Cisco does not care anything about profiles. You can not do what your looking to do at this time. You can use VTP to configure based on a mac address but profiles are well outside what Cisco supports.

Check the rules between the DMZ and internal network. Also check the routing.

Sorry Don't know any. put smartbits in google. Go to the netcomsystems page. It's a test set and it's very expensive. Neteng

You have to look on Cisco's web site and configure switch in VTP. netEng

The smartbits can simulate Multicast traffic. You need to by the unit and the Multicast Option.

It's also not a greate idea to have all your circuits on one line. If the DS-3 goes down your whole office will be down. You really need atleast 8 T-1 before you consider using a DS-3. ALso you will have to pay the same charges for a lot of the port charges for the T-1's they break off. You...

NO the clockrate doesn't limit the bandwidth it switches the line to internal clock. To limit the bandwidth you need to set up rate limiting. See Cisco's web site on how to do this. It's not to hard.

Do you have the clocking set to line or internal? It should be set to line. NetEng

U and W usually are special loads for special features. Either use the W code or go to the next point release. 12.1. You can try 12.0.7 as well but the code may not have been ported. You can check out a entire white paper cisco wrote on the IOS Numbering and releases. You can get it from CCO.

The standard in most large enterprises, who have upgraded, today is to go with all layer 3 switching in the core. Basically what your doing. I would configure each switch as it's own VLAN and assign a subnet to each one. You will have to take into consideration on how large your subnet should...

No you have to turn portfast on every port. Check out the web site on how to config portfast enable on the the 2948. It's something like spanning-tree portfast enabled. You have to do it for each interface. I don't think the 2948 uses range commands. You can write a perl script to create the...