Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Triton101

    Cisco CUCM 9.1.2 <<-->> CS 1000 Via H323 - Hold Resume on AVAYA phone produces one way/n

    here is an example of a scenario where codecs cause issues, this example was for CS1000 and avaya red CM: http://support.avaya.com/public/index?page=content&id=SOLN204147&group=UG_PUBLIC __________________________________________________________ Find a job you love and you'll never work a day...
  2. Triton101

    SIP Trunks To AVAYA Aura

    try this first: Configuring SIP Trunks among Avaya Aura™ Session Manager, Avaya Aura™ Communicat... ... routes and trunks • Administer route list block and distant steering code • Administer node SIP parameters • Launch NRS Manager • Administer service domain • Administer SIP gateway...
  3. Triton101

    Certificates on Nortel/Avaya 1140e IP Phones

    not sure if you can use the VPN wiz to mess around with the certs, if you are running 5.5.1, you can try this ftp://ftp.avaya.com/incoming/Up1cku9/tsoweb/11001200/UNIStim_5.5.1/IPCPVA-01.00_00.25.jar.zip __________________________________________________________ Find a job you love and you'll...
  4. Triton101

    Cisco CUCM 9.1.2 <<-->> CS 1000 Via H323 - Hold Resume on AVAYA phone produces one way/n

    yup, something about a OLC messages (open logical channel on h323) not working properly, it happened with cs1000 to cs1000 h323 calls as well, i don't think it was limited to cisco/cs1000 only. sniffer traces showed calls coming off hold did not get the message from the signaling servers. SIP...
  5. Triton101

    Certificates on Nortel/Avaya 1140e IP Phones

    i'm not sure if you were looking in to the UniStim ntp, but there is a section there on certificates not sure what version you are running, but check this doc out UNIStim Software Release 4.3 for IP Deskphones http://support.avaya.com/css/P8/documents/100113686...
  6. Triton101

    Input issue with Nortel Meridian and VT520 Terminal

    maybe someone moved the cable (to a different tty)? or a dipswitch was changed on the SSC (if you have an opt11c) software change? (Bps changed on TTY) lots of possibilities.... __________________________________________________________ Find a job you love and you'll never work a day in...
  7. Triton101

    Call Pilot Back up to local PC

    in the past i have left the Domain on my laptop to join workgroup, but you have to have admin rights to join the domain again once you are on the Corp network. to join, you will be asked for the login, so you would log back to your domain with a user name: " corpname\username" as the...
  8. Triton101

    Voice mail forwarding on Call Pilot

    voice mail normally sees the "Original dialed digits" and those don't change even if you forward your call to another user. (as this is one reason why centralized voice mail works) you can also play around with Second level Forwarding (SFA in CLS of phone in question), but i think that is only...
  9. Triton101

    Caller ID Problems OPT 11 CSE

    try putting DANI yes on the phone that is forwarding to Cell. __________________________________________________________ Find a job you love and you'll never work a day in your life. - Confucius
  10. Triton101

    Webb

    page 279 http://downloads.avaya.com/css/P8/documents/100121898 table 75 not sure if that is what will work for you but you can check it out. __________________________________________________________ Find a job you love and you'll never work a day in your life. - Confucius
  11. Triton101

    Backup for CallPilot

    had to turn off the tape drive once, failed eventually, maybe popping the tape out might do it, but if the tape is spinning it might unravel so listen to it and take a chance.... if it keeps stopping at that size even after a reboot, maybe you need to rerun config wiz in standard mode and just...
  12. Triton101

    Webb

    maybe you need a pickup group, bunch of phones ring, anybody can answer, but i would go simple with it, and just make an MCR key on a bunch of phones then..... __________________________________________________________ Find a job you love and you'll never work a day in your life. - Confucius
  13. Triton101

    DORG on CS1000E release 5.5

    maybe DORG is for TIE routes only? __________________________________________________________ Find a job you love and you'll never work a day in your life. - Confucius
  14. Triton101

    Polycom 7000 connection to CS1000E configured as SIP Line

    not on sipline, only as sip endpoints in NRS. downside is you have less control over features etc, but it works. you if your Sipline install fails, you can add them to the NRS as SIP endpoints (no license required), so long as you have sip trunks, should work ok. log into the polycom webpage...
  15. Triton101

    Intermittant one way talk path

    what type of system is it (physical, cabinet, chassis, msg, mmg etc)? are the complaints between cabinets? (or IPEs), if this system has MGCs with DSP daughterboards, then it might be the DSPs..... what type of phones? (IP or TDM?) what testing has been done so far...
  16. Triton101

    Responder V (Brekeke server)

    i think the Berkeke communicates via SIP trunks (guessing). so you would need to point it at a NODE IP with Sip trunks (of the CS1K). then you would need to setup your NRS as well for the dialplan to work. __________________________________________________________ Find a job you love and you'll...
  17. Triton101

    KEM question

    if you want to double check, take a look at page 307 on this doc. http://downloads.avaya.com/css/P8/documents/100120098 __________________________________________________________ Find a job you love and you'll never work a day in your life. - Confucius
  18. Triton101

    CS1000M-MG/AACC/Callpilot IVR integration

    on the ACD did you chose IVR yes and ALOG yes? What is the status of the agents? (on callpilot, pbx, AACC). can you log in to Voice Item maint and listen to your recording for that callpilot App? if you can include some printouts, maybe someone else can catch whatever is preventing it from...
  19. Triton101

    Putty to CS1000 Release 5.5

    the reason is you are in a sig sever from the looks of the capture. you are using the command for the PBX part (vxworks). maybe you just have the wrong IP address (assuming you are trying to get into the VxWorks pbx), look for the active ELAN ip of the CALL SERVER...
  20. Triton101

    Polycom SoundStation IP 7000 and CS1000

    i don't believe so, the SIP registrar part changed on 6.0 so it was a real SIP proxy, and for the polycom to work properly, it needed the 6.0 on 5.5 you will most likely get redirect errors since it was not a true sip proxy on 5.5 and below. the call presentation and setup is handled by the NRS...

Part and Inventory Search

Back
Top