Search results for query: *

option 1. a new tandberg tape drive Sorry

sysload

started out as VOD, then went to VCE. Thanks

I agree with vztech, Nortel stated that at this time SIP phones are not supported, but soon will be!

you may get problems with the monitors on the other columns after replacing the main XSM, if you do, just reseat them one at a time to clear.

I am trying to hook up a DTI loop to a rightfax faxserver. There is no csu, just a straight (crossed) cable from the Opt 11 to the faxserver. The fax is recieving a 1 that is being added. I cant see where the Opt 11 is inserting it, in fact I created a dmi table to delete one and it took off the...

I agree with John, try another vendor. The one that I work for, we patch and update Deplists as part of a routine.... Word has it on the street that SBC is getting out of the PBX biz.....

Guys, We are getting away from the original question. What would it matter what type of MPB board that you have, the MGate card hold the switch ports. Until someone can say different, the supported config is the first 32 ports go on the first mgate, remainder would go on the other. The when you...

if you are having any issues, the configuration needs to be correct first, then and only then can you begin to troubleshoot any other issues

call a certified Nortel Vendor, and also, keep your hands out of the PBX

There are new Polycoms that are digital, check Polycom.com for info on the model number that you have

it wont let you build a dch80, only 0-15

replace PWD with PWR, that will work much better

is this an Opt 11C? if so, what slots is the Call Pilot in?

make sure that the number is in fact a DID, not just a number on the switch.

I like that answer. Customers spend alot of money on PFT and the ground start lines that go with them. They most likely have a UPS and back-up generator. Also, everyone has a cell phone today! Yet, I continue to install PFT's?

make sure that you aren't restricting the outbound either on the route or the phantom ports that were built!

Do you have a Meridian mail? if so, at the login prompt type in "tools" and then it will ask for the "admin level" password. Once inside, look for a description like"system info" or detailed info... type in the # and everything will be there that you need. on the...

Red alarm is usually your side of the equip. I'm sure that a cable was cut or possibly a card went bad or something got disconnected.

what type of loop, i guess i mean what are you going to use it for? i.e. superloop, dti/pri?