Search results for query: *

If you stay with the 2270 switch & 2230 Ap's(Airespace equipment),try the Airwave AMP management package. Much better than the Nortel/Cisco WLAN package.We habe the Nortel rebranded Airespace units & the Airespace units running side by side with no problems. Rick Harris SC Dept of Motor...

Are you using the console port ? Rick Harris SC Dept of Motor Vehicles Network Operations

Cisco has a different default mtu than Nortel. Subtract 32 from the Nortel mtu to communicate with Cisco. Nortel to Nortel should not be a problem. Rick Harris SC Dept of Motor Vehicles Network Operations

Is remote desktop installed ? Rick Harris SC Dept of Motor Vehicles Network Operations

Did you "Browse" by NAME or IP address ? Rick Harris SC Dept of Motor Vehicles Network Operations

What kind of CD's are you trying to "read" ?Were they "burned" with a utility such as Nero or Roxio? You may need udf reader sw.Can you read a Microsoft CD or a commercially prepared cd ? Rick Harris SC Dept of Motor Vehicles Network Operations

When you made the cd's did you did you set access for any cd unit or just a cd-rw ? Rick Harris SC Dept of Motor Vehicles Network Operations

Axis cameras are a great low cost solution.We use static cameras and PTZ units. The built-in web server makes it easy to setup. Rick Harris SC Dept of Motor Vehicles Network Operations

Have you reset all the devices ? Dou you have link leds on all the devices ? Rick Harris SC Dept of Motor Vehicles Network Operations

Chech the yellow pages for generators. What is the total KVA load ? Check with the local Caterpillar Dealer;they usually have truck/skid mounted generators for rent. Make sure you have good regulation on output(preferably solid state,not mechanical). Rick Harris SC Dept of Motor Vehicles...

Are the switches all at the same fw & sw rev ? Last resort, init each sw to defaults & reconfigure. Rick Harris SC Dept of Motor Vehicles Network Operations

Pull out the cascade adapter from th 450 that's not in the stack.Power reset the unit.Have a pc on the console port to watch the selftest messages. Do you have the cascade modules installed in the units with xover cables ? I am ASSUMING you verified the base switch setting on the cascade...

What about passwords & SNMP settings ? Rick Harris SC Dept of Motor Vehicles Network Operations

OmegaVTX: It's a problem on that rev too. Rick Harris SC Dept of Motor Vehicles Network Operations

REMEMBER gig e-net does not necessarily mean faster. What about: nics,memory,cpu(s),data busses,i/o buss,disk i/o,etc. Tune your system(tweak)you should notice a difference. Rick Harris SC Dept of Motor Vehicles Network Operations

WAS this a self install DSL or did the telco set it up ? Have you queried the DSL modem with a browser ? Rick Harris SC Dept of Motor Vehicles Network Operations

If you use a degausser on a disc drive,it will be rendered useless. There is a servo track on the platter;when it's damaged or erased,the HDA is useless. Use a DOD-approved eraser,like SHRED. It writes enough bit patterns so that any recovery/forensic software yields garbage. Back in the days of...

Known problem on 1200's with cpu utilization. What rev code r u running ? We would reboot the 1200's in off hours(bi-weekly);seemed to help. We replaced all our 1200's with a 8610 because of EOL issues. Rick Harris SC Dept of Motor Vehicles Network Operations

NetworkView will map your network using SNMP. It's a flat file,but has a lot of info. Rick Harris SC Dept of Motor Vehicles Network Operations

On BS470 you must install the SSH BOSS code. Rick Harris SC Dept of Motor Vehicles Network Operations