Search results for query: *

The V-2924A tip/ring (W/Bl pair) on P7 block is providing intercom dial tone and talk battery. To this phone system, this appears as an outside phone line. An FXO (trunk) port should be used to interface to the V-2924A. According to documentation found online, the Mitel 5485 provides a...

If a page port is connected to the Tip/Ring input (W/Bl) on the V-2003A, a contact closure is required on the Page Port Contact Closure (W/O). The same connection is required even if the V-2003A is used for single zone paging. If the Background Music input (W/Gr) is being used, simply feed...

phone system > V-9921HF connections: loop start trunk port > W/Bl pair strap W/S pair to W/Bl pair strap Bl/r to G/W power supply > V-9921HF connections: negative (battery) > Br/V, S/V positive (ground) > V/Br, V/S

bill4comm is correct. See the following document: http://www.ipofficeinfo.com/docs/Paging.pdf

Also, set the trunk type to WAT

The V-2003A will not provide a pre-page alert tone.

No it is not. Just look for a date code on the unit. It should include a month and year.

Yes, as long as the date code 2007 or newer.

The age of the V-2001A is our problem. I don't believe the pre-page tone option became available until 2007. Unfortunately, upgrading/modifying the unit to achieve this is not possible. A new V-2001A is needed.

does not stop until the Nortel Page times out" ...the relay associated with the page port should close when the page port is activated and open when your page is complete (phone is back on-hook). I would suggest using a volt/ohm meter to verify the contact closure is normally open. What is...

Please see the URL below. I have marked up a page from the manual showing all connections. If your pre-page tone is still not working, there are a few things to verify: 1) What is the date code on the V-2001A? An older unit will not have the pre-page tone ability. 2) Monitor audio from...

I will test this scenario in the morning and post my results. Try applying a momentary short across PPCC & GND.

If a pre-page alert tone is not needed on the V-2001A, a contact closure is not required when using a page port. But, when a pre-page alert tone is needed, a contact closure needs to be associated with the page port. The installation manual is not very clear in regards to this application...

Keep the yellow/black shorted on the biscuit jack connected to J3. Connect the audio to the top screw terminals (Page R, Page T). Connect the contact closure to PPCC & Gnd located at the bottom of the screw terminals.

fedphone- The only Valcom doorplate speaker that will connect directly to an analog station port is the V-5324004. The button press on this doorplate speaker will emulate a phone going off-hook. The station port will need to be programmed for ringdown; whereas, the phone system will...

Move the black lead on the horn from the "GND" terminal to the "+" terminal on the VP-324.

Connecting the V-9925A to an ATA should work just fine. The Red & Brown leads from the V-9925A will connect to the ATA. Black lead to positive and White lead to negative on the VP-624B.