CS1000 Rls 7.0 Paging from an 1140 ip set to valcom with page zones

[L3voice]

I just put in a new CS1000E with tdm and ip sets. When I page to a valcom unit with a tdm set(3904), acod 7 and then 1 for page zone 1 everything works great. When I try this from the 1140 ip set it does not work, it connects but won't take the zone #. Tgars and Ncos are the same on the TDM set and the IP set so that should not be a problem.

Has anyone else had this problem?

Thanks

 

[GHTROUT]

If you are paging over a "trunk" port, try setting the prompt MANO=YES in the LD16 Route Data Block.



--
Nortel Resources at GHTROUT.com World Famous!
--

 

[ValcomPaging]

Also, set the trunk type to WAT