Search results for query: *

If it's a PIV processor, plug in the installation flash and reboot. It will sometimes fix itself from the flash. Worked a few times for me.

If this is a voip system. The most common cause of one way conversations is the wrong gateway ip address on one of your dsp boards.

make sure your adan tty port has user set to mtc.

go to avaya website and search for this. product compatibility matrix

I'm curious about anyone wanting to use anything that old. Tell us what's going on.

I ran into a problem where on pri's, where some extension's would go to a network prompt if they were dialing a long distance number. If you stayed on the call and followed the instructions you would get a live person. This happened after we had turned on sending out clid to the network. Some...

are you using a 2GB flash drive. A 1GB is not big enough for 7.5.

actually admin login is changed on security server. Just login with internet explorer, go to user administration and change your password. I think you can also do it at login screen.

The call server is running on vxworks. winscp is used with operating systems such as linux and windows.

If you send the main number instead of the set's number, you should be able to make calls. They don't have the number on the set as flagged to a long distance carrier.

the login name is root. The password is whatever it was set at. Call your old vendor.

one thing, you need to clearleader not set leader. reboot and run setup.

change fna to fnd in cls.

usually that means the user was built in ld 17 before security server was added and also built in the ucm after it was added.

forgot to give the instructions. put the active cpu into maintence(the one with the good cmdu), disable cni's inactive cpu. Put disk 1 into floppy drive, put offline cpu into maintence, sysload inactive cpu. Than follow instructions in previous post. After you complete install of software...

you need the 17 floppies, a keycode disk and a backup. start with disk 1 which will boot into a install menu. answer the question in the intall menu and change disk when prompted. The last few disk will say done before your hand gets away from the keyboard.

If they are not plugged in and powered up at bootup. The drivers will not load. If it is a windows 2003 system, You can use find new hardware in control panel to load them up without rebooting.

another important piece of information that's needed is this. Are they wet cell or dry cell. Whatever you do make sure the float voltage is set properly for the battery string you buy.

try this type control w. you should see the cobra screen. than type if.

You did not set your pref prompt.