Search results for query: *

to be honest I wasn't sure if it was or not from what I read just thought I would throw that out there.

I found this in the release notes: Fixes for Customer-Reported Problems The following customer reported problems fixes are resolved in Release 5.0 UR5 - no field found issues resolved in 5.0.2.14 - Dpar Description of Problem MN00604453 PRI trunks left in busy out state after yellow alarm is...

I don't know what software level you have but in release 5.0.1.11 the trap below was supposed to be fixed: MN00320952 Main control reset, trap 13 @ 002C049C I would upgrade to the latest I am aware of 5.0.2.14

good to know, I went by the Admin guide Release 2.1 SP5 page 104

in the Multiline Set Keys form I added some Multicall keys for conferencing

my UC360 device type is "UC Endpoint" and the Sip device capabilities defaults to 71 on my 6.0 SP3

300Blackout, how would you block incoming calls on Sip trunks

thanks kwbMitel for the reply

I have a 3300 5.0 PR1 release 11.0.0.105_1 with embedded voicemail. I am familiar with MLAA to a point on the 3300 but was wondering if there is a workaround for the following. What essentially the customer wants is two instances of auto attendant. Currently they have an auto attendant with...

do you have the cos option 620 set to number of call logs allowed for each set. Call logging is available for 5330e and 5340e. You can access call logging from a 5340e sub attendant through the Superkey programmed as a feature key

no call logging on a 5540IP console or Superconsole 1000

I would still do a form print like I suggested, that eliminates any SMDR programming that is missed and proves out your port settings

do you have SMDR in the trunk group, it will be at the top of the form, form 16

change the CDE Data Print to the printer port, test and change back to the extension number

thank you Dan

in form 34 if you have "CDE Data Print: set to the printer port you could form 32 and print a form of your choice I think standard to a DTE device

go to form 34, Directed IO

is there a command available from the rs232 port on the front of a 3300 MXeIII to find out what the System IP Properties areo?

you can change the condition of the room, clean, not clean, maid present etc but not the occupancy. Confirm with your pms vendor the status codes they have match yours.

if *2 is your maid in room code from form 2 then you would dial *2 plus the condition code you have set up with the pms vendor i.e. *2 plus 1 or *21 for maid is present in room