Search results for query: *

The annex B firmware will not work. As you may notice, the description of the device is - WAG54G Wireless-G ADSL Gateway - which basically means it would only work with ADSL.

How long is the cable between the router and the modem? Is he using the internet/wan port of the router? Probably a cable problem between the modem to the router. You might say its far fetch, just try using another cable. Cable should be at least 3 feet but less than 6 feet.If that does not...

Check for firewalls. If they are disabled , then you might try lowering the RTS value of the WNIC into 2402.

The wap54g does not have any dhcp service. It is just a passthrough device.I would not recommend that kind of setup. Use a router instead.

Check the device manager, see the status of teh adapter. If its fine then, refresh it.

Sounds like you have a power adapter problem. That usually causes the router to reboot. Process an RMA for the adapter.

Follow what bcastner has suggested. Also mac clone, some modems have MAC filters. Also if you also get 10.xxx.xxx.xxx. It just actually means that your are not authenticated, even though under status it states connected. Usually verizon gives out an ip address of 151.xxx.xxx.xxx, thats your hint...

That was not a firmware it was actually the setup wizard.

there is not available firmware update yet for the range expander but I think linksys is cooking up a firmware that would allow the range expander to compatible with WPA

kevin, From what I saw on the website they ship with firmware 1.50.18 and that firmware is very buggy.

Linksys does not make a 5 port router. 1 port could be an uplink port. Check the model number, if it starts with BEF or WRT, then that is a router. If it starts with EFA or EZXS then that is a switch or a hub.

That would not work with the existing stock firmware of the router. I am not sure if a hacked firmware will do though.

Don't worry about that. That only a Typo.

Do you have a wired computer ? Does it display the same problem. If so update the firmware on the router.

Can you ping a website or does it say unknown host or could not find host. If so go to DOS and hail "ipconfig/flushdns" and after "ipconfig/registerdns". If that does not work encode the dns on the computer.

update to the latest firmware. linksys has release a bunch of firmwares that resolved dhcp problems , like the one your have.

go to www.centralops.net and do a domain dossier. type in your wan ip and check the service scan. You will know if the email ports is open or not. And if you have norton AV on your computer, disable that.

Browse the CD. Look for the UTILITY folder. And run the Setup from there. It would manual install/reinstall/uninstall the WLAN monitor of that WPC54G.

There is no Vanguard software package that came with the wpc54g adapter. Run spybot or adaware to check if it filters that.

Isolate the problem . It could be the Computer or the Adapter . The best way is to install the adapter on another OS . Preferably another type of OS winXp or Win2k perhaps. The hardware errors that jump from code 10 to code 10 or code 2 upon every installation usually is a dud when reinstalled a...