Search results for query: *

This is expected behavior. The device is a fully distributed forwarding platform, so it will not log these types of messages. It will only give you a hit count. All high performance devices have this behavior. The Cat6500's will do what you're asking, but when that feature is used all traffic...

I assume you're using an ACE module to do load balancing? For the FW are you using a FWSM module? In our environment we use policy based routing to direct traffic to the ACE device. This way only the traffic that we want LB'ed gets punted to the ACE instead of all traffic being processed by the...

Use rapid spanning-tree, rootguard and bpduguard.. Those three features will protect you..

XR is only being deployed on the high end platforms such as the GSR and ASR series. Its mostly alike with IOS, it doesn't have full feature parity yet though.

As this is a switch.. What are you trying to cryto?

Burtsbees is correct.. What you are looking for is 'per-flow' or 'micro policing'.. The policers on normal routers are an aggregate policer. Switches such as the 6500 support micro policing. BuckWeet

So you want to test failover of the MDS 9509, not a Cat6509? BuckWeet

Hope that helps you out.. I smacked my head over and over until I stumbled onto the port# requirement.. I don't believe its documented very well. When I was doing it, I was testing AVAYA VoIP and Cisco VoIP.. The Cisco solution would always compress yet the AVAYA wouldn't.. Turned out to be the...

Being its an ISP, I assume you have Cisco account representatives.. I would reach out to them and have their systems engineers work with you. They will have to review your network topology to give you a proven solution. BuckWeet

One thing through the years I found out with RTP header-compression is that the UDP port numbers have to be within 16384 and 32767.. I experienced one-way characteristics like you until I corrected the port #'s.. BuckWeet

Someone correct me if I'm wrong, but I thought radius doesn't do privilege levels? Meaning that you would always login with exec mode and have to 'enable' into privilege mode. I haven't used radius in probably 5 years, I'm rusty!!

While we're at it, why not upgrade to the 7k's and use VPCs ?? LOL

As this is will probably be a heavily used link, I would enable some type of queueing on the interface. This will help users receive a better experience overall. To be simple, just go to the interface and enable fair-queue. If you wanted to get more extravagant, especially if you have voice or...

Yea they would have to do a total hardware refresh to run the newer code. Resulting in much more expensive processors and added memory.. I doubt it will happen anytime soon..

They won't change this in the CCNA for a while I bet. XR is only used on carrier grade gear. NX-OS is used on high end datacenter gear.. CCNA is more for branch and small site level of hardware.

Cat 3508's are IOS only.. I would try from scratch again as burtsbees said. The MD5 checksum doesn't match, so some paramter is incorrect. I believe it should match on every switch.. Someone correct me if I'm wrong please. BuckWeet

Its because when you bring up the tunnel the static routes that you have for the tunnel interfaces kick in.. Which is fine, but the tunnel destinations are in the same subnet as the static route you have. When the tunnels aren't up those static routes don't get installed into the...

You do have a trunk between the two switches? Could you show the config of the trunks?

Sometimes you need to trigger a VTP update to make them sync up.. Also make sure the password is the same. Go into the VTP server and add a vlan, then exit. It should sync up after this.. Go in and delete the vlan you just created. BuckWeet

Yes overall the commands are the same.. There are some features that aren't in the XR code yet, but they're coming.