Search results for query: *

well no u dont need to take out the flash im saying just in case that the ss is couldnt load the software . usually when u are doing it from ss the ss install the software and the right loadware then he also make the reboot and the card is register by him self of course remember to go to ld 14...

u right my fault anyway u have to check the bandwith of the network u have .

the really bad news it cant be done even if nortel will issue rel 6 . the more bad news cut your presale had how u can make voip network without vlan , qos , layer2 and 3 switches where is the networking here the codec this is like to start f16 with engin of mootrcycle . someone here even...

u never configure tlan on cs u cant do that u can only elan tlan u configure on the ss elan u configure on ld 97 and ss . once u add the ipmg u go to ld 97 and add new with the elan - ip . once u bootup the mgc u configure the mgc where he will register wich means primery cs , alternate 1 or...

first i must tell u that u get wrong answer cause mc32 its mc32 ok ? u cant load the loadware of mgc to the mc32 its bullshit it would never work its different card and the dsp hd&ld not the same as mc32 have . well i can advice u to the few steps : 1.go to the mc32 by cli and format the...

well first if u have the new hms 400 so i cant help u but i install hms 400 and u cant change the wake up call cause its built in in 18 languges so u cant even choose the only way u can choose is when u manualy do wake up to someone that he's in check in and u choose what will be the languge ...

first : intrazone = for wan not lan interzone = for lan usually for the intrazone u put BQ = best quality and for interzone BB =best bandwith the error u get is let say your intra and inter is 100000kbps and your network is less than this number wich means and 100% peak phones bot be able...

hi mike , u guys talk here about loadware 45 but nortel came out with 46 and now its new one : CSP: MGCCAH17 MSP: MGCMAA07 DB1: DSP1AA10 DB2: DSP2AA12 BOOTCODE: MGCBAH09 FPGA: MGCFAA13 APPLICATION: MGCAAA05 TMDI/PRI: T1E1AA19 to fix your problem u need to connect directly to the mgc and clear...

well barg in or bvk u use only in attendant 2250 as key 0 or 1 look in the ntp under ld 12 u will see it . wta u put only if u want that the extension will hear warning tone when the attendant is barg in to his call. u also have the break in key which means if the attendant want to send call the...

well u have mm 10 as u said and u talk about manue , u have to go to the mm terminal go to option voice administration then look for the dn table . this manue is MS 4000 for example when u fins the ms dn u can press space bar then enter and can see what u have to dial in each part of the...

first: when u go ld 22 req: tid u will get the aux id and tid the same this number u can see on the security which mean the dongle u put on the ssc card , u cant change it cause its became together with your keycode unless u lost it in the installetion and u want new one from nortel.

well if after two rings its go to VM u should check first RCO parmameter the rco 0 is 4 rings check the rco in the digital set or in the 500 set.