Search results for query: *

I was tried, still not work, can't read from folder as "cs1000su" , the NEXT button dim, I can't go to next step.

Background: existing system type: 11c/SSC (TDM ONLY) existing software: Rls4.0 new system type: CS1000E/ CPMG (with MG) new software: Rls7.50 3su's installed on Linuxbased server -------------------------------------------------- I was copied the CF card data onto a USB as ARCH_DB\cs1000su...

hi, easy to recover. You can hit "CTRL+I" on mgc boot manual. 1) type "mgcIPClear" to clear existing ip from mgc card. 2) type "diskformat" to repartition cf card on mgc. 3) reboot mgc card. 4) input existing ELAN & CS ip address , when mgc reboot again, all loadware will overwrite and upgrade...

you can using protocol "ISGF or ESGF" on NORTEL side.

you may disconnected ELAN of MGC between with call server,reboot MGC, using user id with pdt2 and password under the local debug mode.

From Rls5.0 NTP , 11xx series key label stored in call server, but i not sure rls4.5 are same ? mancy

You may check TDM>IP DSP channel avaliable or not?

Hi, you can change lossplan on leader signaling server for ip-phone, it will be update all follower. command below: UKLossPlanSet or LossPlanSet handset <RSLR> <SSLR>

Recommenced you must install MGCCAH19(stable) loadware on MGC.

Hi, Experience for me, it's should be DSP96/32 card problem on MGC, Could you upgrade loadware to MGCCAH19 and with new deplist for call server, it's can fixed your problem. mancy

You can using command "rst tn" on LD117. mancy

Hi, You not need to config secondary cs ip on MGC configuration table if you have only one site, it's for GR site only. luckly! mancy

Dear All, I'm forgot admin password for NRS(COTs)on Release5.0 Navigation, could you told me how to do? can i using command line to do that? many thanks. Regards, mancy

thank's a lot~~

you may change the cadence by ld 56. MCAD 2 for incoming call DRNG. goodluck

Hello, Release 5.5 for CS1KE announced on Jan2008. mancy

Hello, All, How to adjust IP-Phone transmition level on CS1000E when dial out via PRI trunk? thank you very much. mancy

Hi, I have got the problem too, you need to download the new loadware of MGC card from nortel site, then copy and install the loadware to call server under the debug mode. the loadware path located at /u/loadware . finally need to upgrade your mgc card loadware from call server one by one. good...

Hello all, Nortel bulletin noted: DON'T USE CPPM and MGC with new Rls5.0 on 11c cabinet with IPT enabled at that time. no actions no patch at this moment , waiting for Nortel update.

Hello, Can i installed the anti-virus software on cc6 server? mancy