Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

nortel and cisco using Qsig

Status
Not open for further replies.

roc221

IS-IT--Management
Jan 26, 2010
88
US
i have a CS1k rls 5.5 and i need to connect cisco to the CS1k using Qsig. is there anything speacial i need to do on the Noretl side to get the TMDI/ PRI card to link up with the cisco . can i use NI2 instaead of Qsig .
 
you can using protocol "ISGF or ESGF" on NORTEL side.
 
i've never seen a clean intergration with ni2. a search here will get you a copy of my qsig config. those two have been up a couple of years with zero problems.. we use names and msg lamps across the d without a problem.

since i made my trunks ncos 1, users on the cisco side use an auth code from ld 88 for ld.. that's a big plus at my site

john poole
bellsouth business
columbia,sc
 
This is one of the threads that JP has with the cisco to nortel solution. 1017219 Thanks John it worked great when I used it.
 
your more then welcome.. when i built that, i couldn't find anyone that had one working.. including our total cust base. it took a while for a lot of users have used that one to date

john poole
bellsouth business
columbia,sc
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top