Search results for query: *

Forgot to mention that there using digital phones, mostly 2410 & 2420's

We have cm 6 and a new AVST Repartee voicemail, ever since the voicemail upgrade, missed calls are not showing up on our phones if someone leaves a voicemail. If a voicemail is not left, then the missed call does show up. I'm thinking there maybe some changes that need to be made in the...

We have CM 5.2 S8300 with an additional 8300 as a lsp. From what i've been told, It does its maintenance routine at 10:00 each night, and just since about a week ago, we are getting a FSY alarm at the sametime. Everything seems to be working fine and no other alarms. Could this be something on...

Have a remote office with an IPO 500 v7, and on Saturday it rebooted for know apparent reason. When I look at the system status under control unit audit, under event type it says Cold Start, and a few columns over it says Sytem Reboot. Is there any other logs I can look at to find out what...

Just had our S8300 upgraded to the latest 5.2.1, when I attempt to access the system it locks up after a few minutes, sometimes I can get a little further then other times. Somtimes I just can't get access. After I wait a few minutes I can get back in, then it just locks up again. Anyone else...

Can you flip flop the boards to see if the problem follows the board. Like Simreal said, make sure the MedPro and the data switch ports are set to 100/Full duplex on both boards.

Thanks, I'll take a look Can the housekeeping time be changed..?

Is there a way to recover deleted vm messages..?

Our MOH is working system wide. Can we just turn it on for certain user's..?

We have a IPO 500, were looking to use a couple of 9620's at a couple of salesmens home offices. Can we use their internet connections for this or do we need a direct connection to our network at their homes. If we use the internet how does the 9620 know how to connect to our network, is there...

Have you tried to make the hunt group extension 790, and then add the 2 reception ext to that hunt group, the coverage path for the hunt group should go to VM, the AA extension in VM should be 790. So if a call comes over the incoming trunk, it should ring one of the receptionist phones, if no...

The gateway is registered to the 8300, the serial number was changed in the gateway configuration, but do we need a new license installed with the new serial number of the new G700..?

We have a bad G700 at one of our sites with a few users, I have a used G700 in its place and its saying that its registered, but I'm seeing a license error. I assume a new license has to be installed, but why would that have to happen..?

On the 2nd page of the station form, do you have it setup..? you'll see these 2 choices on the 2nd page, is there anything configured there. MWI Served User Type: AUDIX Name:

Looking to add around 150 ip phones, are there reports of some kind that can be run to see if we need to add Clans or more MedPros..?

http://support.avaya.com/css/appmanager/public/support/Downloads/P0433/6.0.x

How about if you create a vdn for the zero target, and then point that vdn to a vector that routes to messaging for B's exten.

I believe you have to have Avaya change something to turn on alarming for the PRI's. If I remember, when the PRI goes out of service it alarms just as a Warning and not a Major alarm, thats the part that Avaya would have to change.

That's it, thank you

Do you have backups..?