Search results for query: *

For CO Connection, the program number is 400. For outward co access the codes are 405-407, Day/night/Lunch For inbound ringing 408-410, Day/Night/Lunch. If yuo need the programming manual, give me an email address and I will send it to you.

system model?

Another point to Note, If you have installed the latest programming tool, the is sometimes an issue with the latest tool connecting to systems with ver 3 or lower on KXTDA with CTI Cards. I dont know what model you are connecting to but try upgrading to the latest MPR file. This issue happens...

also check your settings in the smdr options. set the RC condition and AN Condition to "Print". this will show additional lines for the same call 1 line for recieved and addirional line for Answered.

firewall nit a problem and you can ping the pbx, so have you checked that the port numbers on the cpu have not been changed or deleted?

If you dil'd CO5 to Extension 120, Have you checked that 120 is assiged to the the jack number you dil'd on co 5. Another option is to disable Parellel connect for the same jack if a 7k series phone was previoulsy connected.

then all the co's are restricted from been accessed by jacks 11 to 24. you will need to enable them in programming, CO Out Day, Co Out Night and CO Out Lunch.

set your unidentified network to a home network. this is a common issue with win 7.

Yes, the new version Of tool for pbx.s and TVM's have the windows 32 bit and 64 bit Drivers for USB. Network interface and serial has always worked.

Ahh, so you used a tweesers to crack the nut

That system is dying. So your going to take more money of the customer to go through more misery. Let them bite the bullet and change it before it bites the dust

I have had those alarms on lower versions of software. Once I upgraded the PMPR to version 5 and flashed all the cards the issues disappeared.

The OGM is for the Disa\AutoAttendant, youe needt to set up your voicemail message on your extn, then forward (bust no answer option)your extn to the BV Card.

record a ringrone tone, stick it on an mp3. plug that into the music on hold port, voila you got ringing while transferring.

Hi SMBC2010 If your using Eiecom then your in Ireland and using the UK version of the software. The forward extenal setting is Press sp phone press rwd/dnd Dial 69 dial phone Number Dial # press sp phone that will forward the call out as long as the DDI or main ISDN Channel is ring direct...

yes a Disa is your best and cheapest option, it will detect a fax signal, you just program in the Fax Extn.

1. Power up the BCM Status - Orange solid Power - Orange solid 2. Wait 5 seconds When the power light starts to blink orange, press the reset button ONCE. 3. Then the lights are Status - Orange blinking Power - Red solid 4. Wait 5 seconds When the both lights are blinking quickly...

if i remeber rightly, there is an issue with migrating from BCM400 to BCM450 5. The seems to be a problem on KRS, once you upgrade to ver 5 and try to add additional modules at a later stage, the 400 will not accept the v5 key. BCM 400 still thinks your entering a 450 key. i am sure there is a...

Do you have 2 full pra ccts. if your 2nd cct is fra you could be selecting channels that are not available.

I dont think the problem is with the BCM. I would expect it is with the Telco. They control what Numbers are sent to the call receiver. If you have a PRI Tester you should be abe to see what numbers the system is sending.