Search results for query: *

Check the time of day routng plan. VDN is 1, phone is 2.

Check your codec's. Had the same problem a conference bridge from a remote site. Changed to G711 and it flew.

You should still log into the IPSI and lock it down to 100/full.

It is the FAC plus extension number.

No can do. Consoles are their own special hunt group and will not ring at the same time.

For PRI's, you would have to set up a route to that particular trunk group and do a trace to see what channel you end up on.

We had to busy the IPSI before we did the changes for it to take.

It sends all of the translations. That is why your local trunks are last in the route patterns.

ARS digit conversion is pretty self explanatory.

S3500 MSS DVD drive won't open. Worked once after a reboot but has since quit. Have a ticket in with Avaya to replace drive but I don't think that is the problem. Developing.

Have you checked to see if any of the ports are marked?

You can do an export data, from ASA, to find out which stations have various groups assigned. Should save mucho time.

add an analog extension with the line appearance as a brdg-appr and wire a bell or light to it.

gblucas It does not matter which slot the card is in, they are all connected to the TDM bus, the layout your BP describes is the way AT&T used to lay out the carriers; station cards start at the left, trunk cards right, meet in the middle.

The firmware is incorrect. Product Correction Notice link: http://support.avaya.com/japple/css/japple?temp.documentID=296417&temp.productID=201940&temp.bucketID=162024&PAGE=Document

It's been a while so bear with me. Somewhere in voice system administration there is a number range defined. Number services administration and call transfer administration should help you out.

I don't think you can do that. The switch is looking for the status of the extension, in the hunt group, to route the call. It doesn't know about the bridged appearance. Set up a 6408 with 8 call-app as an x-port, cover to a cov answer group.

Change or remove the recovery rule from the gateway so it will not reregister.

Possibly because you are using static addressing, although I'm not sure.

If the arbitration link goes down the IPSI's will register to the servers they are connected to. Don't work too well.