Search results for query: *

Do you have 24-09-01 set for the Virtual Extension like the other extensions?

22-02 set Night Modes 2-8 to DIL 22-07 set Night Modes 2-8 to your Inmail Pilot number

What do you want to happen during Night Mode. Depending on what you want to do, this could be rather involved...

Trial & error. Different carriers have different settings. On our Clearfly accounts I found we had no outgoing CID and tried different ones and found it had to be Carrier C.

Can also be programmed from the phone. What are you looking to change...

Does anybody have a cheat sheet on how to program Ray Baums Act on a SV9100. I need to program a Netlink site and the manual is confusing. Thanks.

Good morning, does anybody have a configuration guide for setting up a 3rd party SIP extension. Customer is having a security gate installed and they need a SIP extension. I can't find any info on NTAC. Thanks...

FYI...The network engineers ran Wireshark with call examples. The network engineers had me reboot both SV9100's and after that it works fine now. The network engineers said that when they installed their new equipment sometimes the MAC Address's do not release from the NEC equipment. Never...

I totally agree and on our previous conference call I told them NOTHING in the phone system has changed and it broke AFTER they made changes. Check routing, ports, SIP ALG, etc. One site is all Digital & Analog phones and the other site is all VOIP phones. Both locations have their own SIP...

Have a customer that has IP-KCCIS between 2 locations that has been working with no issues for years. They recently installed Velo Edge 620 equipment and ever since then they have 1 way audio between sites. They say no IP Address's changed. I informed them to make sure ports 10020-10531 are open...

I have had phone displays go bad as well over time. Some you could reboot but over time they went blank again. Swapped out the phones and everything was fine. Brought back the bad phones to the shop and let them run and they went blank over time with no load on the blade...

I had this problem when we went from CP-10 to CP-20. In 84-33-01 (Fax Relay Mode) for SIP Trunk with CP-20 should be disabled. With CP-10 it was enabled. Just a thought...

Try turning off 20-13-06

We have the DECT Wireless phones on one install and they stop working. Coincidentally the SV9100 gets constant "IP Conflict" alarms and it is the only install with Cisco switch's and I have been told ARP Probing on the Cisco switch's can cause problems. We had the IT company turn off ARP...

Nevermind...

Has anybody had any success with Clearfly SIP trunks on a SV9100. Followed the config. guide from NEC with no success. Does anybody have a config or working download for Clearfly? Thank you...

Did you try 7133?

Don't forget to enable 20-07-01 for the COS of the Inmail ports...

Are you using a analog extension from the SL1100 into a FXO port on the other end? If so, try setting the analog extension in 15-o3-03 from Normal to Special. Hope that helps...

Do you have any SLT's available. If so put the SLT extensions in 20-37. Set what extensions are going to use which operator in 20-35. Program call coverage keys on the phone's of the associated operator's. If you want to create virtual's, you could CF/ALL the SLT's to the virtual's and then...