Check the alignment of the left side of the carousel.
Small white gear with two little nubs on the shaft that drives it.
Line up with mark on the top of left side of carousel.
Same with the right side. What is consumable life? Fuser also.
check if it has release lever still up.
"Impatience...
Am I irritating yet? Or, Are you irritated yet?
Britishisms really chap my hide.
To me, it is snobish, and most of the time mumble-jumble.
Took months for me to understand a Kiwi I worked for.
Elocution seems to be lacking, and haphazard at best.
Right, then, Bob's yer uncle!
"Impatience will...
The personality chip may be faulty, resulting in errors.
Try updating the network firmware, even if same, could be glitchy.
Or just go ahead with the newest version. Install it as a 32 bit.
"Impatience will reward you with dissatisfaction" RMS Cosmics'97
Oh, I eat peas with honey,
Ive done it all my life
It may sound kind of funny,
But it keeps them on my knife!
Dont know who wrote it, but I think that peas has an e on the end.
"Impatience will reward you with dissatisfaction" RMS Cosmics'97
Im with hpwizzard, DC Cont. is probably the culprit.
Plug printer directly into wall socket!
"Impatience will reward you with dissatisfaction" RMS Cosmics'97
The H/V is going bad. Possible to have got a bad developer, but doubtful if the same error would be there.
Nothing obstructing it from seating correctly?
Put a mark on the edge of the cyan OPC roller to see if it is rotating.
"Impatience will reward you with dissatisfaction" RMS Cosmics'97
If you can connect to the EWS in a browser, you can make changes to settings.What things did you find? Error code?
"Impatience will reward you with dissatisfaction" RMS Cosmics'97
Print the config page to see if it acquired an IP address.
Check network setup in the menus for auto or manual. An IP can be put in at the printer. When installing driver, select that port.
"Impatience will reward you with dissatisfaction" RMS Cosmics'97
Is this the "internet"? It all seems so wrapped up in a web of illusions. It's the Interweb!
Ennui, it's just an app away.
"Impatience will reward you with dissatisfaction" RMS Cosmics'97
Secondary service menu, "clear techrep faults"
Should get it reset. clear all that are there[it's one at a time} NVRAM Reset also. May need twice to sync properly.
"Impatience will reward you with dissatisfaction" RMS Cosmics'97
You might be able to adjust the temp for the media you are using. Check the paper settings, and the maintenence settings.
"Impatience will reward you with dissatisfaction" RMS Cosmics'97
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.