Recent content by LUBBZ

Ok, this one is off the wall but I thought I would ask. Does anyone know if there is a ring voltage filter that can be bought for POT lines? I have a customer that bought a call recorder but without help from the recorder company he is supposed to filter the ring voltage. We know how we...

Don't forget while programing your phone to use PUA in the CLS.

Ok. I had somewhat of an issue with this before. I did not see anyone else mention it so I hope it works for you. FCDR in ld 17, PARM is where you can select old or new CDR format. ld 17; Req. Chg TYPE. PARM BCAP. a...a (speech)or 3.1KHz (speach is default, enter through) - FCDR (old) Hope...

Not sure why it does that but I have found that too. I print to file so I have it on disk then print from there. If I don't care about the file too much I deal with the gray background. Andy

Do you have HFA (hands free allowed) in the cls? Might want to check that before trying another set or showing us the programing for the set to see what else it may be. Andy

Hi. In the programming for the attendant console, change the ICDR (internal call detail recording) prompt to ICDA (internal call detail allowed) ICDD (internal call detail denied) is the default setting. Once you do this a L-Record will show in your CDR. One thing to note, you must have the...

Thanks Bignose21 I know that bouncing the controler may help but I am not even positive that my remote is the cause of it. Also, I work for people where any service outages are very negative. Thanks for looking. If and when I do figure it out I will post it.

I have a opt 81 and after having a power issue in one of my remote IPEs I am getting AUD518 when the audit runs in the background. It never goes back to AUD0000. The message is; AUD0518 Less than 10 percent of the XMI message registers are in the idle queue. I have searched every NTP and...

HFD, HandsFree Denied in the CLS, it is for the 3900s and i2000s.

That was a great suggestion. The port on call did not do it but it was a good idea to look into using the headset jack on the set and checking the options. By putting the cord in the headset jack instead of the handset jack I was able to go in the options and set the on hook path to the...

I have several 3900s with push to talk handsets (3T-PTT from TWACOMM.com) and there is something odd with their operation. When the handset is picked up (push to talk not pushed) the set goes to speaker. The user has to push the PTT button, hit line key, then flash hook to connect the call to...

Yes it will work. ICDA on a analog or digital will record internal network calls to your CDR. Incoming and outgoing calls made from the TN with ICDA will go to your report. On your CDR these calls will have a L designator instead of a N or S. I use this on several phones that need a record of...

You can also use a store bought usb to db 25 cable to connect to the switch TTY cable (gender benders may be needed). Then select the port used on the Hyper/Procomm program. This works if your com. 1 is in use for something else. Otherwise, like in the above posts; com. 1 is the best bet.

Cant you use a radio speaker output to a ULIC? Then use that route for music. I have never done so but have heard older techs talk about it. It would only help for music though, not RANs.

In addition to changing to E 7 1 make sure the ProComm terminal is set to 9600. Its a easy click and point at the bottom of the screen.