AUD518

[LUBBZ]

I have a opt 81 and after having a power issue in one of my remote IPEs I am getting AUD518 when the audit runs in the background. It never goes back to AUD0000.

The message is;

AUD0518
Less than 10 percent of the XMI message registers are in the idle queue.

I have searched every NTP and have not been able to find any information about XMIs in a queue.

What do I need to do to clear this and to get my audits back to normal?

Thanks.

 

[bignose21]

Cannot really find anything on this. There is a patch about message registers not going idle during inventory MPLR21438, not quite your problem.

Also have you tried taking it all back down and reseating the controller.

Thats power off shelf
ld 32 DSXP x
then reseat
power on

let the card go through its self test (HEX messages are in the input/output system messages guide) it finishes up with LED flashes three times and remains lit until the card is configured and enabled in software. Then the LED goes out.

ENXP x

 

[LUBBZ]

Thanks Bignose21

I know that bouncing the controler may help but I am not even positive that my remote is the cause of it.

Also, I work for people where any service outages are very negative.

Thanks for looking. If and when I do figure it out I will post it.

 

[bignose21]

Good Luck.