Search results for query: *

Installed a Starplus STS with 24 bt phs. Put system back in default. The first 8 phones work. The additional DTIB in slot 3 that should support 8 more is not responding. can't seem to find if i need to tell system a 2nd DTIB is installed. Any help would be appreciated.

Here is a blast from the past. A customers home system is a Vodavi 616 EK. I can't find in the manual how to program line-4 from a mul button back to line-4. There is 1 phone that has L-4 on it appearing & ringing but no other. I can get into programming. Checked for no privacy, no restrictions...

Thanks JerryReeve, Great sugestion I'll look into it.

Thanks hawks and exsmogger, Great advise on passwords, but no one listens till they get a bill from telco (usually 5 to 10 k )before they change passwords from 123456. Thanks for your help!!! Gary

Thanks hawks, I'll give that a try.

Customer wants to remote access MICS 7.1 by calling DID (L191) and enter a password then be able to make International calls. I tried using rem access line but system will not let me enter any line number over 156 (last before DID range) Any thoughts?

Thanks again byrontel, Again wishful thinking. gkurk

Thanks byrontel, Just wishfull thinking I guess. Gkurk

Can I change DN lenght from 2 to 4 without reprogramming?

I have CICS with 2 digit ext & want to replace with MICS with service card & T-1 card for PRI, no expansion card needed. Can I keep it at 2 digit extension so I don't have to reprogram CP100?

brown705 You could always limit amount of message storage in class of service. gkurk

Norteliva, Can you access F983 and get into main programming? What is software ver on C? Must be 2.0.4Lc Could be bad hard drive.

mynus, Set target line prime set the extension. Is Call Pilot set for NVM. (not CP) Try making target line appear & ring on set. Reboot CP & MICS (MICS first then CP after MICS is up) gkurk

lynmar On a fastRad the mem cap is round black and standing up on end. The one I am looking at has GC 5.5V1.0F on it.I just take a bare wire hold it on each side for about a minute then check with meter. I never had it damage one but jerryreeve might have a point.

lynmar, You can also open unit and short mem cap this will set to default too.

thicks70, What system? Is a button stuck down for an internal intercom that is named REF SNA? Try unpluging set to reset. Could it be a bad display? Does any other buttons work? Feature * 0 to check other buttons.

bkrike, Thanks! I did read the FAQ799-3640, and I will try it.I know I did it on another system alot easier but can't remember how. Thanks for your help. If I can get back to the system I did it on I'll post it.

Had same problem with remote ** to access mailbox, changed channel cards, hard drive and adjusted dtmf delay still had problems. Put in a flash all problems solved. I think it could have been on main board.(It was the only think left!! try to find one of those)Almost not worth fixing old...

telcojoe NT5B01 is the 6x16 cabinet number. It could have Dr-1 to DR-5 software in it. Just power down and pull up software to see, hopfully it has a good cap to hold memory in it.

I had two customers get hacked lately. I had customer change mbox password to 6 digit,(you can also make them change it through class of service every so many days)change allow redirect to N, in mbox programing dont allow out bound transfer.