Customer wants to remote access MICS 7.1 by calling DID (L191) and enter a password then be able to make International calls. I tried using rem access line but system will not let me enter any line number over 156 (last before DID range) Any thoughts?
Set the Target Line to a DISA DN
Build a COS with Remote Package and password
Call into the DID you should get Stuttered Dial Tone, then you can enter your password and make a call out.
I may have missed a step here but someone will fill in the blanks. Good luck
Hawks covered it well. Also make sure you have access codes assigned to your pools, or destination codes/routes built for dialing back out. Make the passwords difficult to guess. Don't use 123456, etc.
Follow exsmogger's advice and I would also let the customer know that you are not responsible if any one hacks his system and makes unwanted calls. Not likely to happen if he keeps up the password changing but you never know.
Great advise on passwords, but no one listens till they get a bill from telco (usually 5 to 10 k )before they change passwords from 123456.
Thanks for your help!!!
RikRodgers, I would suggest to any customer that can afford it a call accounting package that has a tollfraud watchdog built in. telco will only forgive one time for toll fraud and maybe not even then.
----------------------------
Hill?? What hill??
I didn't see any $%@#(*$ Hill!!
----------------------------
JerryReeve
Communication Systems Int'l
com-sys.com
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.