Search results for query: *

Is anyone aware of where i can download the manager software for the KX-TDA600 running release 2? Thanks, Thanks grifc

I am trying to transfer keycodes from a Callpilot 200i system to a 201i, but keep getting error "error decoding system". Can anyone assist with this procedure. I also tried reloading operating system on 200i however the system is requesting that i load MSDos 6.2 via a flashcard. Does anyone...

All, Thanks for your help the password was retrieved. grifc Thanks grifc

Do you have a pri test set? An easy of verifying where the problem is by using a pri test set to make the call. If it works with the test set then the problem lies with the cs1000. You can also turn on d-channel messages to see why the call is being rejected. Grifc Thanks grifc

Hello firebird, Can you advise on how I can obtain this password. Do you think that nortel tech support will provide it? Thanks for your assistance so far. Grifc Thanks grifc

Hello all, I would like some assistance in resetting the Callpilot manager password for a Callpilot 3.0 running rls 3.0 software. I have the server password and would like to if there is a way of using this account to reset the CPMGR password. Thanks grifc

Does anyone know where i can find neridian pbx features training videos? thanks, grifc Thanks grifc

I have tried reseating the card and changed the power supply, but this did not help. Thanks grifc

I agree with Dasheen is a good option is your succession has VOIP trunks available. The norstar VOIP gateway has FXO ports that connect to the analogue trunk ports on the norstar. To the norstar its just another trunk connection, all of the VOIP configurations are done on the VOIP gateway...

I have a callpilot mini installed on an opt 11c rls 25.40B. It has stopped functioning, after it is rebooted all the LEDS keeps blinking in sequence from 1 to 4. I removed the PCMCIA software to my laptop and i am able to see all the software files. Does anyone know what i can do to determine...

The problem has been resolved, we had to reconfigure the dialing plan on the NRS. Thanks, grifc Thanks grifc

When users from an option 11c site running Rls 4.5 software attempt to make PSTN calls via the NRS they get "release and try again" and the following error is display on the NRS: "LOG0003 NPM: cmEvRASReject: GK Admission rejected channel 32". Calls to other endpoints on the network go through...

Hi DKL22, Thanks for your assistance, everything worked out as suggested in the thread. Grifc Thanks grifc

Hello Atascoman, We did make the changes in the LD97 which links the SUPL to a IP address. What we discovered was that during the initial setup of the MGCs, 2 of them were assigned the same IP address and this caused a conflict. So the problem we are encountering is that when we try reconfigure...

We are trying to upgrade from a CS1000S from Rls 4.5 to CS1000E Rls 5.5, the upgrade go through ok however to of the MGCs seem to be conflicting. When both MGC 0 1 and 4 1 are connected to the ELAN, MGC 4 1 display shows 0 1. The deplist for the call server and MGC cards have been loaded. The IP...

Has any one used the MP 114 and MP 202 IP ATAs from AudioCodes to provide a remote analogue extension over a IP network? Thanks, grifc Thanks grifc

This problem has been resolved apparently there is an issue with the 4 port paddle boards supporting PMS. Changed to a 2 port all ok now. Thanks grifc Thanks grifc

Just to confirm, the BCM does register with the NRS, CS1000 users are able to reach sets on the BCM. The problem only occurs on outgoing calls for users on the BCM. grifc

Is there an application that can be used to test the PMS interface on a meridian system? The PMSI connection between the meridian 1 option 61C meridian mail and a hotel's property management system is not functioning. The supplier of the property management system claims that they have tested...

All of the configurations you have suggested have been set however i still receive the same error message "No route to Destination". When i monitor using BCM monitor i can see the VOIP trunk being seized and the correct digits being outpulsed, but this only last for a split second. I have...