Search results for query: *

when it comes up in maintenance to you get an opption to do a cold reset. If so select reset and power down when you power back up it should reset

Sounds like the power supply is good. Trash the rest.

would a ccr tree(poor mans acd) handle the volume.

would it be system programming/feature settings scroll until you get to set relocation.Thats where it is in 3.1

Thanks Silver 987 I thought that was it but wasn't sure.

We have a MICS with 7.0 software with copper lines. We would like to set the ringing on the system, so that it rings different on incomming calls than internal.

are you forwarding the ext to the vm dn

Change date to 09/15/00 Press feature 9** display will read " password" Press the left soft key 5 times press the middle soft key 5 times press the right soft key 4 times press the hold button press the "2" key press the "1" key press rls and rad is reset

Just plug the rad into any avalible port on the system. Use a regular base cord for a phone. Rad pass word and baude must be set. Set to answere line for direct dail in.

the book that comes with a DOC doesn't give much information that would help you. I gave you the connections. Pins 7 & 8 are data in. Pins 9 & 10 are data out. The door phone is the interface between the KSU and the DOC.

How are you going to control it. With a push button?

To wire the doc terminals 1&2 12-24 V AC/DC. connect the first door striker lead to terminal4 connect a jumper from teminal 1 to terminal 5 relay common connect the remaining door stiker lead to teminal 4 N.O. Or terminal 6 N.C. Terminal 7 and 8 is the door phone connection.

There is a kit with a cd and floppy disk. You use a piggy back cd-rom drive. I think that your hard drive must be at least 480 meg .

That depends on the size of the old hard drive

are you just upgrading to 4.1 or are you replacing the hard drive

What type of system do you have. Do you have C.I. cards. Is caller I.D. info being sent from C.O.

Thanks for the info. We are trying to get them to put a U.P.S. on the system.

about 24 hours

We have a 8/24 at a site that loses power a lot. The system started losing it's programming a few weeks ago. we replaced the memory caps in the software sleve. It still looses programming after an extended power outage. Does any one know how long it should retain programming? Is the programming...

Short the pins out again preferbly over night. Initalize the flash with 1.7 0r 1.9 software then reboot with 2.0. This has worked a number of times for me.