Search results for query: *

Looking for suggestions, Analog line powered caller id set preferably with MW light. Thanks.

Any work arounds to access the SMI on CM 6.0 and older using the latest versions of Firefox, Chrome and Edge. I have the same issue with access to System Platform Cdom. There was a way to modify Edge to use Internet Explorer for specific sites, but that seems to no longer be working.

We have installed CM10 with smgr 10.1. Avaya J179 sip phone with bridged appearance, after a call is answered on a bridged line the next outbound call is not selecting the prime line. There is a previous thread with the same issue 690-1797163, stating a firmware fix in release 4.0.4.0 we are...

This might work. Not sure if it applies to only outgoing calls or all trunk calls. Page 2 of the cor Outgoing Trunk Disconnect Timer (minutes):

Once a J179 has been converted to H.323, Is it possible to set it back to sip? Gone through the menu and set sig to sip, the phone reboots but remains H.323

Resolved. TN790 processor was the issue.

Not a Prologic. Processor is a TN790 with a TN765 proc interface. No alarms on the system, list measurement ds1 runs clean too! Had a vendor meet and telco proved issue to pbx. 1 pri in pbx, and 1 connected to t-bird. The pbx pri "reset" the t-bird one did not. I did order replacement...

I have 2 pri's, the system is sending a not ready to telco via the d channel. telco then sends a reset. Spans do not drop, active calls do not drop. New callers get a fast busy for approx 15 seconds. Repeat every 15 minutes. G3v6i.03.1.230.6

Am i correct that patches need to be installed thru the cm web interface like we used to back in pre 6.0 and system platform days?

If this means I have to create a postmaster mailbox, I have not. Found some info on shadow/postmaster in the documentation. I will give it a try when I am on site. Thanks.

CMM embedded voicemail on an S8300. Everything works with the exception of the ability to forward a msg to another subscriber. System response- extension not valid!

sounds like redirect notification.

root/root is default but installer is forced to change it after initial login, the password can only be reset from the console or services port on the mg.

give each station the cos with console permissions, cha console parameters pg 2 common shared extensions.

I had an S8400 that we could not login to using asa,telnet,putty or http. I have never seen a system actually pass the 30 days. So I assumed it had gone into license error mode. The system was up and running, but had alarms on the server. We were reluctant to reboot the server without spare...

S8400 cm 5.0

What happens when the 30 day grace period expires?

Because 6.x uses mac address, you could put your spare ipsi in the 6.0 system and use your original ipsi in the lab.

I think you would have had to create a new license file in rfa using the new ipsi serial number before you converted your licenses to plds.

It will work, I have done 5.2 to 6.x upgrades. The lsp's are upgraded first and they do receive translations.