Search results for query: *

How do I create a new dchannel as a primary and one as a backup When I config the dch in ld 17 pdch is not an option

excellent thats what I finally got done how about the clock controller it is in loop 0 shelf 0 slot 2 my clock is in freerun as there is nothing connected does this look ok ld 73 Req prt TYPE ddb MGCLK 0 0 2 PREF 0 0 2 SREF TRSH 00 RALM 3 BIPC 2 LFAC 3 BIPV 3 2 SRTK 5 30 SRNT 15 3 LFAL 17...

Thanks thats what I thought I was going to have to do

I need to add this card I have no config right now I have the card in cab 0 slot 2 I have done the ddb In load 17 how do I add the card cequ the dlop command do I just chose a loop and how do I refer it to the card in 0-2

Ok Thx why do my trunks stay disabled

Do I need a clock in a Cabinet before the IP trunks will enable the are all disabled now and I am assuming it is because there is no clock installed at this time. Thanks

When you boot release 5 there is no preconfigured database only a default which has nothing

I have a rel 5 to install is there a preconfigured default database like the opt11 or cs1000s

You can also schedule by using prog service sched (day, night1,night2)daily ) 08:00 then turn on by prog serv sched on prog serv sched (day,night1,night2) on or off

What type 3300 the dsp at the rear left is the one for tone and conf. If it is totally bad you will get no dialtone.

Please submit your programming on the card and slot the card is in. Need to see system config cab assignment and your descriptor I had this working ok in my lab

Need Min Max if oyu want to restrict the number they are calling to or 6160 to restrict a certain ani number

you need q stream for 4000 series sets P only supports 400 series. Q45 is what you need but you need a new moss sheet and possibly a new hard drive. You need to look at the requirements as you need extended file system.

Formprint (form name) Multiline set assignment /port lpr3 then type en pri /non have procomm set to raw ascii and start your download amd name the text file you can do and form by name or all forms, or an instance

Body/Solutions In 2007 Daylight Saving Time begins on the second Sunday in March and ends on the first Sunday in November. This pattern will be followed by all US states and Canadian provinces which observe daylight saving time. Previously, the US and Canada had observed Daylight Saving Time...

You dont have Opsman or another controller IP in your DCHP scope ? Sounds like the set thinks its resilient.

Only for parts as the SYSID will be tied to a site or a company and you wil not bbe able to get licenses on it. If it has licenses you will be ok for that number but will not get more. For parts only $750

I had 2 sets an I2004 and a 3904. I built the I2004 first then the 3904. The I2004 was not working and the 3904 would not forward til I deleted the I2004. Is marp causing this and is there a way to assign the 3904 as the mail or how do you control the forwarding on a MARP set.

Escape 2 to range program leave blank hit esc 2 again enter number of lines it will blank this many then commit and confirm.

There is a way to access the IP config on a set without rebooting, does anyone know this ?