2000 night mode

[jazwinner]

I'm aware of being able to check / change status of the systems day/nite1/nite2 mode via station dial-up. Is there a way to check mode from the main. term.?

 

[fonejack]

I asked this very same question to a Mitel instructor and was surprised to hear there is no maintenance command to check service. You can however switch service from a maintenance term with the command “cp service”

 

[jazwinner]

Good info - thanks!

 

[Lundah]

It's not the most efficent way to check, but if you don't want to switch service and don't have access to a phone to check via FAC, you could search the maintenance logs for "service" and you should see the last service change event.

 

[TETech]

You can also schedule by using
prog service sched (day, night1,night2)daily ) 08:00

then turn on by
prog serv sched on

prog serv sched (day,night1,night2) on or off