Search results for query: *

You can tenat trunks in the trunk assignment form

When you use winzip or another program backup.tar\\vmail\temp\db\backup\vmail you will see *rad001.vox *rad002.vox this is your recordings

For ISDN E1 it is the same as for ISDN PRI on a Mitel

hex continues to scroll host. Older 201i hard drive ok I can put in another 201i. Monitor ok works on another 201i

yes no video at all cant reimage

Its pretty hard to install rel 5 improperly I am trained on rel 5 and wrote the exams. One cabinet with PRI. only programming in system was a PRI and AMWLC and the min requirrements to make a call out plus the tds and conf and dsp. I like release 5 and the ip connectivity but we had an issue...

Sorry didnt get notified of responses there was corruption in sw had to reload. This new rel 5 is a charm Thanks to all who replied

Turns out the set came with vlan 1 hard coded removed and set to no vlan all ok

No video went thru nortel recommended steps remove ram etc no good starts up t01 thru t08 no errors scrolls at host anyone had any success with this.

Who is the network side? Is it E1 pri? or qsig?

Thanks John did what you said worked like a charm

If I change the rlb prompt mfrl can I have it so only sets that are set a an ncos too low for LD to get prompted and all else not. Or is there another way

When running an install again I get an error master and standby config must be on the same subnet. anyone seen this I only change the settings that are on the main install I do not see a master and standy referenced

Does the management port require a special cable

Thank you to all

Go to the set and press the superkey and logout or assign a code to acd logout go to the set and dial the code and it will logout the agent

If you compress a route with no dsp or compression licenses you will get an alarm on the pbx

I had this issue last week uninstall ops and reinstall and you will be ok

I have 2 new 860 and only have serial conectivity since it is all fibre gbic. Can someone help me in assigning an ip address to them. I see a initial setup but do not know how to save it since it is all command line. Thanks You in Advance

The opsman permission groups still have the same permissions as the old if you access the program from the old url xxx.xxx.xxx.xxx/ops/mitel/topa.asp the user has to be in one of the Mitelopsmgr groups created in windows then the old permissions apply