Search results for query: *

I am looking for an example ARS setup for Selangor, Malaysia. I was able to find a few pages about dialing properies there but nothing that was all inclusive. Thanks in advance.

I am getting an error "no instance number available." Logging in as vm with 4410 and 513 emulators. Has anyone seen this, know a fix? Any help would be great. Thanks.

Check out this document, it should help out with the importing: http://support.avaya.com/css/P8/documents/100065247

I am trying to convert an old MCC carrier from DS1 connection to IPSI control connections. I have been looking for a while for a diagram on how this looks with no luck. Is there anyone out there that has something that I could take a look at? Or a cabinet layout? Thanks R

I have a customer that has 4610's and 20's Ip sets. When a call is made the call timers starts on the display and when the call end the timer keeps incrementing. Does anyone have any knowledge of this and how it may be fixed? All of the phones are at the latest firmware 2.9. Thanks for the help.

a ping and telnet

Yes and Yes

port 1

I have yet to load any software, thats what I am trying to get done. I have statically applied 192.11.13.5 to my PC. Still no response for the services port.

Hello everyone! I have been looking at this for a little while and figure I could throw this question out to everyone. I am trying to load a new S8720 with CM 4.0.4 and the service port is not responding to anything I do. Does anyone have a suggestion on how I can fix this? Thanks for the...

Since both are cold patches, there will be a reset system done at both the deactivation and the activation. Hope this helps!

update_deactivate 730 patch then update_remove 730 patch then update_unpack 731 patch and finally update_activate 731 patch. Thanks. Randy

Make sure there is a "copy run start" done on the G250, before shutting down the gateway. That wrights all the changes into flash for the G250.

Everyone, I am working on a G350 with a MM314 (24 POE switch) and the gateway/mm are having some troubles. I am getting a "workQPanic: Kernel work queue overflow" whenever I have the module inserted. When I take it out the g350 boots normally. Has anyone run into this before, and if so how...

I would also check the speed and duplex setting on the network switch and the ports in the G700.

In this case the CLAN reference would be the IP address of your S8300 if that is your main server. Are you using a DHCP server for these phones are you statically administering?

Go into bash and the pub dir and type: rm "filename". That should delete the file for you.

Is there anyone out there smart enough to get this working?? I have changed the station to enable softconsole with video, I have the station registered with the switch but no video. When the status comes up I can see that it sees the webcam but its not registered. Please help!

what CM version are you running? If you are running 4.0 or higher you can create an admin account with the craft login

Just figured it out!! stop -r is reset stop -a is shutdown