g250 fails to register after reboot

[mrjedi]

CM4 s8300 g250 latest patch. Run installation Wizard, gateway registers. Then reboot system, it doesnt register again. Have to re-run wizard tocome back up

 

[Mitch672]

sometimes you need ro run "configure server" to get the IP data to become permanent (on the S8300 processor). Its a bug, but usually this is only needed once... then try a total system powerdown, and powerup, and it should work... I do this on all systems before I ship them out, I call it the "powerdown/powerup" test, to verify the IP address's and settings have remained.

mitch


AVAYA Certified Specialist

 

[rlance610]

Make sure there is a "copy run start" done on the G250, before shutting down the gateway. That wrights all the changes into flash for the G250.

 

[mrjedi]

Mitch672
The IP addresses are not lost. I can log into the g250 and allthe settings are there. I will try the configure server option.
rlance610
Did that and still didn't work