Recent content by SIDO1

Hi Guys! Does anyone think a Dongle is needed to make the CIU and the smile 2.4.1 program to communicate as reguired? Althought the help menu says a Dongle is optional. I cannot see incoming calls on the smile program and cannot make any call form it. Incoming calls ring out only in the M2250...

I'm not sure what ur AC Voltage level is, if 110V, try 220V. If persist, try with the working SSC. The problem seems to be SSC hardware power level related. Do you have another power unit for you 11C?

Many Thanks Guys, I moved TN and TN2 to a different position and the Red light disappeared, now green. The previous TNs on card 5 are bad. I am now battling with the SMILE 2.4.1 software to communicate with the M2250 console interface unit - CIU. SMILE is not interacting with the CIU.

Mike Thanks for your contribution, I can disable and enable TN & TN2 but not power TN whether the pc-console is powered up or down. The front indicator on the M2250 pc console initially fluctuates between red and green when powered up and finally turn red instead of green. This means the pc...

when the PC Console is powered down, the TNs become IDLE while the TN for PWR remains DISABLED.

3902 and 3903 do not have same features. If you need to keep a record of the configs of the 3902, print it. then OUT it and build 3903 with the same TN.

LD 32 reveals that the TNs are Busy and the TN for PWR is Disabled. The Self-Test on the M2250 Pc-based console was ok. Does any one know the serial (DB 9) port settings for the interface?

Hi Guys, I set up a new M2250 console with SMILE 2.0 software but its not working as expected. TN1 - white/blue, (TN2 SETN)- white/orange and TN3 (PWR)- white/slate. The front LED flashes between red and green for sometimes and finally turns red. The LEDs on the rear flashes red for a while...

The PWR for 2250 is connfigd using a TN of a port in a DLC. Hey! I stand to be correctd. You probably need a new DLC.

Hi MagnaRGP, Pls understand me. I dont want you to take some else's issues. I only want to meet you say, "off camera" if you dont mind. sidomultilinks@yahoo.com Meanwhile the post from ld 143 is; >LD 143 CCBR000 .MDP ISSP VERSION 2121 RELEASE 4 ISSUE 50 W + DepList 1: core Issue: 01...

MagnaRGP Many thanks for this insight. I'm not sure if I want to be falling back on my Vendor again. Slow rate of response is a reason. Pls can I meet you? sidomultilinks@yahoo.com is my email.

MagnaRGP Thats a very help tips But one thing I'm not sure of is what do you mean by 'blow the SSC' and how is it done? Rgd

johnpoole, Don't you think this issue is caused by hardware failure relative software? I have a similar issue on an option 11C on 4.5,when I tried with another SSC from one of remote cabinets, it worked. I'm not sure if PATCHing can do it. Best regards

When 'A' calls 'B' & B's line is engaged' 'A'can activate 'ring again' when 'B's line is free, 'A' will recieve a notification to call again.

Many thanks for your very useful contributions. I'm now clear on how to build corporate directory. Bravo!!!