Recent content by mjoetech

Just did and it works.. PHEW! Thanks. Joe

Hello all, I am really struggling with a re-installation of a Flash vmail. I installed the two ports (4 channels). However, I cannot get into it via F983. I keep getting inactive feature. In fact, I get this with all Feature codes used for vmail. When I dial the DN of the Vmail (241), I get...

Hello all, I am really struhggling with this Flash 2.1. I installed the lines as above. However, I cannot get into it via F983. I keep getting invalid feature. In fact, I get this with all Feature codes used for vmail. If i dial the DN of the Vmail (241), I get a login. If I dial the DN...

Right. The expansion is in there. I will go back tomorrow and remove two ports from the wiring. I think I need to re-initialize as well. Thanks for your Help! Joe

Thanks CurlyCord.. I was putting two KSU ports on each jack. I thought a 4-port Flash needed 4-ports of KSU. Joe

Hi, Somewhat new to Norstar and wondering how I wire up a 4 port Norstar Flash. I thought i wire up two phoen ports on each jack, but didnt work. I installed one port on pins 2 & 3, and the other on pins 1 & 4. I did the same with the 2nd RJ11 jack for a total of 4 phone ports. Is this not...

I was working with this agai this morning and from my ASA I can ping the VLAN gateway which is on the same subnet as the PBX. However, I cannot ping the Corp LAN IP address. Is there something I need to program in the Avaya to see the subnet of the Corporate LAN? Thanks!!!!!, Joe

Yes, I can ping the Vlan port address from the routers. Thanks. Joe

Mitch or ?? I am in the system now via the web IP. I dont see where there is an "ip interface page" as stated above. I did find a page to option the interfaces and the only thing there was three LAN connections with their respective IP addresses. There is an option to check for VLAN. I...

Ironically, If I put circuit 2 into the tn464 card, it comes up. If I put circuit 1 into the mm710 with it programmed as B, I get a different reading on the Smartjack. It shows Up, but the D channel is OOS, as are the channels..

I would like to reach out to the communittee here and ask a telco provider question. As I stated above, I have two identical circuits from the same carrier (paetec). I was recently able to get the 2nd T1 working by changing the TSC Supplementary Service Protocol to "A" in the signaling...

OK thanks, I am remote and dialed into the modem. I'll have to wait until I get on-site. Thanks again!!

Thanks Mitch, I can seee where the Medpro has that option. My question is; If i set the Medpro and CLAN's "VLAN Option" to "2", how does the PBX know what VLAN 2 is, or how does it know to route to the Layer 3 switch's gateway?

Mitch, My VLAN 1 is 192.168.80.180. I have a lot of users working off VLAN 1, which consists of all the switch ports except the one port assigned to the Avaya (VLAN 2). My VLAN 2 gateway is 192.168.169.25. This VLAN 2 is the gateway to the avaya which has all devices with a 192.168.169.xxx...

OK Thanks, The ssh was enabled in the access server screen. In fact, everything was enabled except FTP. I built the SAT in "ch ip-service" I made it as shown. I'm not sure if this is correct, but I still cannot ping any PBX devices from outside the VLAN. Any other suggestions, or should I...