Struggling with a flash vmail re-installation

[mjoetech]

Hello all,

I am really struggling with a re-installation of a Flash vmail. I installed the two ports (4 channels). However, I cannot get into it via F983. I keep getting inactive feature. In fact, I get this with all Feature codes used for vmail.
When I dial the DN of the Vmail (241), I get a login. If I dial the DN of the second port (or any other channel, I get a busy. Yet when I look at the DN's in the Key system, they show Idle.

Any suggestions?

I should add that this KSU and Vmail were removed from one church and being installed at another, so the ICS system and the Vmail are compatable.

Thanks,
Joe

 

[misseditbythatmuch]

Did you do a Feature 903 during the reinstall? I think you need to do this with 1.9 and later Flash v-mail software to set the feature code set to standard defaults.

 

[mjoetech]

Just did and it works.. PHEW! Thanks.

Joe

 

[exsmogger]

Just press the OK button when it asks for a key. This is only to enter a keycode for extra features if you have one.

Brian Cox
Oregon Phone

http://www.OregonPhone.com