Hi,
I built a VLAN on a layer 3 switch port that matches the IP subnet scheme of the Avaya PBX (CM 5.2). From the Layer three switch i can ping all my devices on the PBX. However, I cannot setup my ASA to access the PBX's CLAN, or procr port. Is there something that needs to be done in the PBX??
I noticed in the CLAN board (ch ip-interface 01a03) there is an option for VLAN. Do I set this to a specific number? Is there anything else needed?
Thanks so much!
Joe
I built a VLAN on a layer 3 switch port that matches the IP subnet scheme of the Avaya PBX (CM 5.2). From the Layer three switch i can ping all my devices on the PBX. However, I cannot setup my ASA to access the PBX's CLAN, or procr port. Is there something that needs to be done in the PBX??
I noticed in the CLAN board (ch ip-interface 01a03) there is an option for VLAN. Do I set this to a specific number? Is there anything else needed?
Thanks so much!
Joe