Hi,
I have a G650 (CM 5.2) that has a 464 tT1 card. The PRI is connected to the Carrier and working. I have a G430 in the same equipment rack as the 650. I want to install a second PRI in the same trunk group as the first, but using a mm710 in the G430.
The second PRI into the G430 shows Out of service on the D channel. However, if I unplug the PRI from the mm710, and into the working 464 in the 650 it comes right up. I have both PRI's programmed Identical. I checked my cables and they are correct. (straight through into the mm710).
I think the problem may be the connection between the two systems but not sure. The G650 has an 8400 and the 430 has an 8300 installed. Can anyone suggest what may be wrong? (I swapped mm710 out as well)
Thanks!!
Joe
I have a G650 (CM 5.2) that has a 464 tT1 card. The PRI is connected to the Carrier and working. I have a G430 in the same equipment rack as the 650. I want to install a second PRI in the same trunk group as the first, but using a mm710 in the G430.
The second PRI into the G430 shows Out of service on the D channel. However, if I unplug the PRI from the mm710, and into the working 464 in the 650 it comes right up. I have both PRI's programmed Identical. I checked my cables and they are correct. (straight through into the mm710).
I think the problem may be the connection between the two systems but not sure. The G650 has an 8400 and the 430 has an 8300 installed. Can anyone suggest what may be wrong? (I swapped mm710 out as well)
Thanks!!
Joe