Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by bigindian65

  1. bigindian65

    Gene Trouteaud passed away this morning.

    R.I.P. my friend TSB Mato' Was'aka
  2. bigindian65

    one way talk path on IP sets

    How do your DSP resources look? Sounds like you might have an MGC DB problem Mato' Was'aka
  3. bigindian65

    Put two netwok on the same subnet mask

    You have to chg to a diff net one of those like 192.168.6 nothing is going route if it thinks it's on it's own network already. Mato' Was'aka
  4. bigindian65

    NPA conflict with NXX

    your nxx has 1 in front? Mato' Was'aka
  5. bigindian65

    RAN announcements with 2 members

    30 RAN 64 Music Mato' Was'aka
  6. bigindian65

    Local Exchange Carrier

    ideally, if cost effective, it is always good have local routes and then dedicated LD. Then, they can both be Entry 1 opposite each other on the RLIs to back each other up. Mato' Was'aka
  7. bigindian65

    Ringing continues for seconds before the person answering the phone is connected through

    You could still make them an ACDN so they would get queued calls to their sets. Mato' Was'aka
  8. bigindian65

    Block Annyoing Calls

    You can if you have Symposium or AACC, but it is usually a waste of time, as sending diff CLID, or unknown, track phones, etc make it about impossible to effectively block. Mato' Was'aka
  9. bigindian65

    display show DN plus N, H, L

    Sounds like RESN in ld 95 CPND might be set to yes instead of No. Redirect Reason Codes. Mato' Was'aka
  10. bigindian65

    Outbound calls becomes not ready.

    Could try checking Answer By Placing DN Call on Hold in Configuration- Call Presentation on CC to see if it helps? Mato' Was'aka
  11. bigindian65

    Display a name based on DNIS

    you can name what you need in ld 95 Mato' Was'aka
  12. bigindian65

    SMG1000E installation

    do you have an NWAY RMD? Seems like every time we do an upgrade they leave out the SMG software and just send the stuff for the main. Mato' Was'aka
  13. bigindian65

    How to send Buzz to headset and not a phone

    off hook? on a 2216? Have you tried switching to call forc on the ACDN? Mato' Was'aka
  14. bigindian65

    TRUNK OVERFLOW

    All it really does is optimize call proccessing, looking there first to know how many entries are available. Mato' Was'aka
  15. bigindian65

    RLS YEL ALRM

    is that the only T-1 you have? swap cables with one next to it if you can. See if it stays on port or follows the telco coming in. Mato' Was'aka
See more

Part and Inventory Search

Back
Top