Recent content by 9201

For AUD029 check TN 12-0-1-9 either out and rebuild on another card. BUG279, check your DTR the other are minor happen are the times.

In Call-Pilot Advance Search, click MWI and put in the extension of the phone that light. You might see other mail box lighting that DN.

Every channels or just here and there? try move to another cabinet.

I think the problem is at that other company.

Do you have PTY build? REQ prt TYPE adan tty 10 ADAN TTY 10 CTYP PTY DNUM 10 PORT 0 DES PTY_PORT0 FLOW NO USER MTC SCH BUG XSM NO TTYLOG 0 BANR YES

Can not be done..

Card properties

Look at the boot up..ELAN and TLAN mac:ff:ff:ff:ff is the problem.

Ld 60 .stat (enter) You can not tell which t-1 or (PRI) is local and LD on the screen. Some local t-1 (PRI) allow you to dial LD so you need find out from your provider.

What IE are you using? and you doing it right on CP server or from your desktop?

No the PBX system do not store call informations, once the call is complete and user hung up the data is gone.

Questions: 1- Yes SS 4.50.88 is the latest will work with 4.5 2- yes.. you have to reboot SS with new CD in the cd-rom drive to get to install/upgrade 3- No, SS does not automatice upgarde VGMC you have to do it. Read the VGMC documentation it will tell you how to do it. 4- SS 4.50.88...

D-channel 10 is your IP Trunks tie to another site..if you have IP trunking between building yes its a concern.

Before any upgrade to release 5.0 and up get the 2nd level password 1st. If you can not get them, after the upgrade load the software again and choose utility option then restore the default password. This will restore both level 1 and 2 back to 0000 (4-zeros).

All COTs auto terminate in Callpilot need to be GROUND Start or you will have disconnecte issue.