I have a Digital Trunk programmed for a dialogic card. If you call internal the route/DSC works, if you call from a cell phone or call the DID from our cs1000 it works. If you call from a residental or POTS line it goes to the operator "0". I have checked all of the programming and can't figure out why some calls work and others do not. I can post any copies of the RLI, DSC, RDB programming as needed. Thanks in advance for any help!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Route Goes to "0" instead of programmed DSC
- Thread starter kwoerner
- Start date
- Thread starter
- #41
Sorry for the response time, but this is just one of my current issues, I appreciate all of your help. Being at a healthcare facility I cannot always run the risk of just making software changes to see " What happens if you ENL DCH 35 in LD 96?" I have to make changes off-hours and get them approved first.
But, once again, thanks for your suggestion.
But, once again, thanks for your suggestion.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question