Search results for query: *

If you want to program a custom routing, it has to be at the intercom path. You can't intercept and route digits dialed directly on a line. Also, you can't "1xxx5551212" as a destination code. Your best bet is to set up either an arbitrary destination/route or a system speed dial to dial...

Does anyone know which phone system Wal-Mart uses that has the ring (similar to norstar ring type 2) followed immediately by a short tone? (sometimes two short tones)

Anyone have any ideas or information on the protocol, etc... the norstar sets use? Also any information on the audial frequencies of the rings, pages, tones, etc would be greatly appreciated. I'm a very curious coder who's interested in seeing how something like this works.

109 is the highest in the CICS system.

I just got an ATA (not an ATA2) and am hooking it up to a CICS. I found out real quick that the features (Flash-*) and the M7100-like hold code (Flash-2) doesn't work on this one (give you a fast busy or silence). I have figured out how to page... Flash-6-0 (not 6-3-0 or 6-0-3-0 or 6-1-0 or...

What's the difference between an ATA and an ATA2?

Intercom paths time out? When did this happen? In any case.. another alternative would be to have every line that they have access to appear on your set. Then you'd be able to tell if theyre using a line or are using an intercom path. Or if intercom calls aren't needed, you can just remove...

You can do what i've seen done before. Go to each set and pry off the Feature key and place electrical tape over the hole.

What exactly is the actual frequency/frequencies of the "page tone"?

If i remember correctly, the bug is when a "1" is pressed on an intercom path. While the system runs the routine to determine if any DN/routes/park prefixes/etc begin with 1 (which would return "Invalid number" if not), it runs into an infinite loop.

I've had problems with CICS's somewhat like what you're talking about. We have 6 lines, and they A & R on all 15 sets. If more than 2 lines are ringing at a time, strange things happen (phones don't answer any line when you pick them up, pressing line buttons puts the calls on hold instead of...

Yes. Unplug the set and then call the extension and make sure it says "Not in Service" after a few seconds. If not, then you either have another set tied to that extension, or you have two extensions crossed somehow. Also, you might want to try unplugging it and then disabling and...

Listening in on a line while someone is on it is possible by turning off the Privacy setting for this line, but it is *not* "secret". All this does is allow you to add yourself to the conversation as a conference call at will. The person on the phone may notice that your set's name/dn appears...