Search results for query: *

Hi All, I have about 12 different BS450 stacks with about 4 in the stack with a BPS as a the base unit. The problem is on one specific stack I get random ports locking up. The state of the port remains up but no traffic will pass. The SW is 2.0.5.20 and FW 2.0.5.3. Is there a known problem with...

The router exams have now been stopped and you can no longer do them.

Have you checked your pin outs for the cable you using. If you look on the Nortel website you will find the pin outs.

from BCC type config then the interface type ethernet 0, serial 1/1 then type ip address x.x.x.x mask x.x.x.x hope this helps

do you already have a new image file

thanks for the help I will get some one to check this next time. the last the stack crashed was now 11days ago.

I just lose connectivity to the stack and have to get someone to reboot the stack as I am not based on the same site and no one can console into the stack to check what is happening.

All, I have a stack of 3 450-24T swithes that has crashed three times, reason unknown at the moment. I have about 4 other stacks with the same number in the statck with the FW - 1.48 SW - 4.2.0.12. I cannot anything in the log either. Has anyone had a similar problem or can anyone suggest...

Hi, The straight Cisco cable will work fine to connect via the console. FRom there up can configure the ethernet port using BCC. To change the ethernet port IP ADDRESS 1. type bcc (then type config, you will get the config prompt up with a #) 2. type ethernet 1/1 3. type sho conf -r (this may...

BNFS runs on 95/98 only. If you have a later OS then you probebly want to use Site Manager.

dont forget you need a X-over cable to connect your laptop or pc to the router ethernet port.

You router is set for a network boot, its looking for a config file from a remote TFTP server. No bootp server address is configured on that interface so It cant find the server so it looks for a local config file but that doesnt exist either. It could also mean that the flash card maybe...

Send me your email and I will mail you a copy of SM and tell what routers you have and will be able to send you the latest RS

Thanks

The traffic filters are configured under the specified port, either ethernet or serial and so on. If you send me a copy of the config (sho conf -a in bcc) and the log entry using log -ffwitd -eTELNET. Are you using SNMP to connect ? You may want to check if your telnet settings. I have a copy of...

Does anyone know how to set trusted ports on the BPS 2000 using the CLI. I am not able to use a browser as I dont have a direct connection to the BPS. Cheers Xplicit

you can view frame relay commands from the bcc using show frame relay ?

You need to run the above commands from BCC. Once in BCC if you do a show ? this will tell what commands are available.

BCC is bay command console. It is another type of IOS that runs on bay/Nortel routers. If you type bcc from the TI you will go into the BCC. From this you can run similar commands to cisco...