Search results for query: *

I had to run as an administrator (right click and go to properties, under compatibility and select run as adminstrator) to get this to work - xp setting still came up with the same error

this is located in the plus.log file in cvr1 directory

I am getting an Error 16 - INITMODE set to C without SMDIUSED - Using normal mode Any idea what this means and should I be concerned about it

b is definetly NI2 - i use it all the time

Since you have analog lines you can always get the feature from your carrier. I have ran into many troubles forwarding to cell phones in the past from all different kinds of systems.

TYPE RDB CUST 00 ROUT 5 DES 2WAYDID TKTP DID NPID_TBL_NUM 0 SAT NO RCLS EXT DTRK YES DGTP PRI ISDN YES MODE PRA IFC ESS5 SBN NO PNI 00000 SRVC NNSF NCNA YES NCRD NO CHTY BCH ISAR NO CPUB OFF DAPC NO BCOT 0 DSEL VOD PTYP PRI AUTO NO DNIS NO DCDR NO ICOG IAO RANX NO...

It is some kind of answer supervision problem - are there any options for this - may want to turn it off and try.

DS means disconnect supervision - needed when you have voice mail

Clock will still be a slave - only 1 master clock source

In all cases - open a ticket with your carrier - get them to check there logs or even find a time when they can take down the circuit and test - also get them to check for timing slips (if it is timing slips then it will be your problem - another post). If all this shows clean the the problem...

Thanks - works great now

Here is a PRI D channnel level 3 message from the carrier and with OLI on the sets the pbx is still not sending the caller id info - any ideas what else it may be 08 Q.931 Call Control Message Call Reference Value Orig 16 05 Message Type...

Is there a way to set up outgoing caller id for the individual did's on CIC's with PRI service - clec says we control caller id and only see the main DID going out no matter which DID calls out - is there a control for this in the programming of the pbx

Any ideas how to get a second PRI to work on a MICS with 6.1 - the second PRI comes up but unable to call out on it - 5ESS switch set up with 2 PRI D channels and the co says that they see my call go over the second PRI but grap the 23 trunk - everything shows in service

How do i check and change timing for 2 T1's. I want to change timing from Sprint T1 to a PaeTec T1 to hopefully fix timing slips?

My problem is that if you call from outside and Station A answers and transfers to Station B it will not go to Voice Mail. If you call Station B direct it will go to Voice Mail ok. I have tried this on 2 different NEC 2400 systems and it does the same thing. Any ideas would be appreciated.