Outgoing caller id - CIC's with PRI

[marktfsmith]

Is there a way to set up outgoing caller id for the individual did's on CIC's with PRI service - clec says we control caller id and only see the main DID going out no matter which DID calls out - is there a control for this in the programming of the pbx

 

[NTL555]

Try turning on OLI for the set.

NamLy555

 

[DOcean]

Try turning on OLI for the set.

FWIW - This may work with one carrier and not with others (as well as OLI blocking).

I had two clients, two identical set-ups (MICS/PRI). Only difference was carriers (BellSouth vs. USLEC). BellSouth, although saying the client's system should work, didn't. USLEC allowed a different CID and blocked outbound without incident.

D. Ocean
Miami, FLA

 

[marktfsmith]

Here is a PRI D channnel level 3 message from the carrier and with OLI on the sets the pbx is still not sending the caller id info - any ideas what else it may be

08 Q.931 Call Control Message
Call Reference Value Orig 16
05 Message Type SETUP
04 Bearer Capability Length = 3
80 Coding Standard CCITT
Info Transfer Cap. Speech
90 Transfer Mode Circuit
Transfer Rate 64 kbit/s
A2 Layer 1 Protocol G.711 u-la
18 Channel Identification Length = 3
A1 Interface ID Implicitly Defined
Interface Type Primary
Preferred/Exclusive Preferred
D Channel Indicator Not D Channel
Channel Selection As Indicated
83 Coding Standard CCITT
Coding Type Number
Channel Type B Channel
8B Channel Number 11
70 Called Party Number Length = 12
80 Type of Number Unknown Type
Numbering Plan Unknown Numbering Plan
Number 19495551212

 

[senk1s]

besides enterining the 10 digit number in the OLI, you need to say send calling number
terminals & sets
--telco features
--

 

[marktfsmith]

Thanks - works great now