Search results for query: *

Dave you willhave to disable the CCR tree before you can make any changes to it.

GDK 34 M.O.H. Prog41 / Button 4/ Internal led on External led off

DORO payphones have an inbuilt dial/charging table and don't require meterpulses but need a reversal on answer if I remember correctly

Thanks for that PERRYPJ it did not even mention it in the notes

Oldgoat 47 I attempted to install a second DSS to receptionist on a MICS 0+32. The numbering transferred to the 2nd DSS and the original was dead. Has anybody any ideas on what I have missed. The book says it is just daisy chained on.

Telstra In Australia used to use a system which supported selective ringing and enabled all parties to converse but required an earth at the premises It was installed at the local exchange because it required access to customers' "C" wires. It also set off the fire siren via a separate pair of...

The programming manual is about 60 pages I only have dial up. Tellme what you need now and I will scan it for you Bob McDermaid

Ihave the manual and can scan some pages for you if you let me know what info you need. Its the Australian version so it may not be right on all counts

Dellboy16 I think you will find your system uses a super capacitor to maintain memory. Don't know the value or where you would get one. A U.P.S. might be an easier solution.

Page control is an isolated relay contact to turn the paging amp on and off Paging output is 0.775v approx at600 ohm impedance Aux ringer is a contact only to operate an external ringer

Send me your Emailaddress to oldgoat@iprimus.com.au

I can scan some of the relevant pages for you if you like Bob McDermaid

I don't know where you are but for Australian standards try looking at www.acif.org.au and download the pdf of the rules

It is many years since I have worked on them but I will see if I can find any of my notes on them.

All Ericsson Xbar I have seen has a letter stamped on the relay armature. "eg" lr-br for line relays M for marker R for register etc

If it has 8 verticals in the Xbar switch it is an ARD526

If the system is set to 600 ohms it should work ok in Aust You don't say which type of system it is but I know some of them have pad settings to compensate for short and long lines. Bob McDermaid QLD Aust.

FNC+Hold+*# to get into program mode on port 10 or 11 only Comes up on the display OFF-LINE PROG KEY10+02from keypad and the line keys which light up ring on port10 toggle on or off by pressing line keys Press Mic key and data is stored and it increments to port 11 and so on. For night ring...

Don't need software for the Ranger programming is simple and done from port 10. Email me for what data you need to change

With the phono jack it could be an external paging card