Search results for query: *

Hello, Does anybody know the coode to enter the service mode for WT9620 DECT handset? We've moved from WT9610, where the code was R***76#, but I cannot find anything similar for WT9620. Thanks for any suggestions Pawel

Hello It seems You're using IP Connect mode - in that mode all the PNs are interconnected via IP. You should have C-LANs (TN799) and MedPros (TN2302) in each PN. regards - Pawel

Hi It's enough to utilize built-in switch - You can connect it to Your network, where Definity is connected too and then administer the IP Trunk Pawel

Hi Go to www.vue.com and click Test Center Locator to find a nearest Vue partner Pawel

Hi You can try to connect the recorder between the digital phone and its handset. It should work. T've tested that solution with Joutel recorder and it was OK regards - Pawel

Hi You need flash with MV1.2 software load (48MB 'orange' flash) regards Pawel

I think You can prepare one configuration in the normal way, run another system with the saved translation from the first switch and then install the license file. it is similar to upgrading the older version of Defnity to the actual one best regards Pawel

Hi Follow that steps: 1) ch ip-int to add boards (type: clan and medpro, enter location and node name - default) assign valid gateway IP number and subnet mask and enable ethernet port 2) ch node-names ip to assign the IP addresses and port to the circuit packs 3) ping the assigned IP...

Hi Try to configure analog set as 'CallrId', not 500/2500/k2500 regards Pawel