Multivantage and IP office

[ihatehndls]

How do I connect the two using IP trunking?
Thanks

 

[MauroB]

Hi ,
You have to config an Ip Trunk on MV and fill the ip office ip address in the far end ip add sign group parameter .
Then , into the ip office tab Lines add a new line in the Line - Voip tab fill the MV Ip address .
That's all .

 

[Gibsonic]

im needing to do the same thing. I currently have a pri module in my IP Office. Do I need a special IP network adapter to replace this one or can I just uplink the IP Office via the front network/switch on the control unit to the rest of my IP/Data network?

How about integrating the IP Office to a centralized Intuity? What is required for this?

 

[pprzadka]

Hi

It's enough to utilize built-in switch - You can connect it to Your network, where Definity is connected too and then administer the IP Trunk

Pawel