Search results for query: *

You may want to check the clocking which switch is doing the clocking?

In ld 2 type in SDST that enables the automatic change

Ok first bulid your self a rout (RDB) ld 16 you will have to look up all the prompts it ask for there isent many the main one is ACOD that will be your access code to the paging system once that is done bulid your self a trunk with that rout number in it and what ever TN you use take that to...

In ld 23 the is a prompt called SCB which you can set up to print out basic ACD reports

If you are not useing a headset you will have to take the handset off hook to log in and then you can put it back down once they have log in I think that what you are asking.

Set that hunt and fdn to the first set in your hunt group and make sure in the cls you have hta and fna turned on.

There is circit breakers on the front on the cabnit that control those cards but you would have shelf problems if it was that I have seen digital line card cause that problem before try disabling and pull out one at a time each digital line card and see if the light goes out.

In ld 48 type in acms 9 the aml link will only come back up when the voice mail is done restarting if you do the acms 9 and go in to vmail and watch to see how vmail boots up and watch it all the way and see if it is failing some were it will take vmail about 4 or 5 minunites to come back up if...

Here is what you could do set your overflow to a nother acd Q which is night call fwd to and anlog station with a bell on it thats you cheepest way out.

First go to ld 48 and disable the aml link then reseat the voicemail card (pull it out and put it back in)the green light will come on and then go out for a while enable the aml link useing the acms command. then go into vmail and watch it boot up at first you wont see anything come across the...

2 is probley your spree code and if you look under pick up code you will probley find your 3 and if you look in the programing of your sets the rnpg of the ringing sets are set with the same number.

Sure have the night call fwd go to a 500 port with a ringer on it because if there all in position busy the Q will be in night call foward mode and you can direct it pretty much anywear.

Ya print out you flexible features codes LD 57 that will tell you what is set up for all the features on 500 sets and what to dial to get the feature to work or put in your own if there arent any there.

Take that script and put it in a shared folder that every one can get to from there desk top would work have those users load that file when they login..

CTRL R

I had the same problem click on Control Panel-System-Device Manager- under modems delete the two drivers then reboot your system XP will now see your modem. You must have upgraded.