TO log into the card directly via serial interface
35xx baud rate 9600-19200
38xx baud rate 19200-38400
Connect via Hyper terminal
press return
Username:(enter username for Hipath system)
Password:(enter pw for hipath system)
Command:get write access
command:set ip address 192.xxx.xxx.xxx...
Please check the following settings
Output format = LAN-TCP ClIENT
Set Customer database printout to - v24 port application
Set Call info to - v24 port application
Open Lan Config tab below
tick Radio button
TCP-CLIENT
Set the IP address of the server/PC to output the raw data to.
The...
This is a parameter set in the system under message notification.
You will need to log onto the system with the programming tool to clear it?
To remove the notification on the local device you can try hash 68?
I can help you i just need to understand how your routing is set up?
When does the call fail? e.g. does it allow you to dial it and then you get a delayed message that would indicate that the call via the lcr is correctly getting to the HG1500 card?
You need to cut the problem in half by...
The whole point of the grace period licensing is that i can only be used once.
What licenses do you want to run and why can you not just license the system? If the grace period has expired then what other features are you hoping to show?
Is your LCR dial plan set up correctly?
If these two systems are connected via IP, then the LCR dial plan and the HG1500 or equivalent card will determine where the calls are routed to?
Can you ring the other ext's that you are trying to forward to?
Also remember that you can look in the...
The 3800 is capable of Ip trunking in conjunction with the other hipath systems, as well as SIP. To integrate that into a Panasonic would be questionable.
Any IP connectivity will have to be achieved with a HG1500 card for each system and it has to be licensed accordingly from V5.0 upwards...
Call signalling H223 active voip via TCP client port nos 12250-12950
RTP payload transport active voip via RTP-RTCP / UDP port nos 29100 - 29159.
I hope this clears this up for you?
leekeen@lkscomms.co.uk
www.lkscomms.co.uk
The three bits in the 802.1p field, which is part of the 802.1Q tag, are used on layer 2.
On layer 3, the six bits in the DiffServ Code Point (DSCP) field are used in the IP headers’
Type of Service (ToS) byte.
It is also essential that sufficient bandwidth is available within the QoS class in...
I enclose the full set of the lights and their meanings for the card in question.
I do have some questions for you too?
Red Off
Green Off
Board not receiving power or not plugged in correctly. Board is out of order.
Check plug contact on board.
Red On
Green Off
Board is receiving power and...
What version of system do you have?
What level of software is on it currently?
What type of voicemail is it?
the EVM is a minature daughter board located at the top of the proccessor on the left hand side?
The IVM is a card in the system with an external hard drive mounted on it?
The reason...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.